I have a 1988 mustang convertible chassis that was a 2.3L and now have a 1992 2.3L that I want to put in it. I have the engine harness for the 92 mustang and it is installed but it looks like the dash harness has 2 different connectors that don't match up to the engine harness connector which so far I have traced two of the wires out one to the tach and one to the oil pressure sending unit there is a total of 6 wires and it is a red connector.
Should I plan on just getting a used dash wiring harness or is this a doable thing?
Should I plan on just getting a used dash wiring harness or is this a doable thing?