Wiring up 2g alternator questions

I'm a little confused. What alternator do you have in there now?

Ok... wiring it up is pretty simple and straight forward.

Use the connector located here:
http://www.pa-performance.com/display.asp?sku=28

Read what's on that page. The only difference between what's there and your application is that 2Gs are internally regulated and you will not need to use the white stator wire from the plug. Do not cut if off though. You'll need it when you convert to a 3G.

Edit: You'll need one of these as well. The 2G doesn't have posts on the back.
http://www.pa-performance.com/display.asp?sku=13&rP=searching,cat@Plugs+and+Wire+Kits,cR@categories
The two large ends of this plug will go to the unswitched side of your fender mounted start solenoid. The third white wire will not be used.

You need both of those connectors for the 2G. One is the regulator plug and the other is the power supply plug. Both wires on the power supply plug are power wires. Just wire it up like you would a 3G alt. You're going to need either 2 strands of 10G wire or you can wire both connector wires to a single 6G or larger. Whatever floats yer boat. If you're going to eventually switch to 3G alt anyway, then go ahead and install a large 4G wire from the alt to the terminal post.

I'm not sure if Autozone will have those parts or not, I've pretty much given up on the parts stores with the exception of the most basic stuff. If a parts store doews have them then they're likely to have only the plug and you'll have to install wires and terminals yourself. I doubt that they will have the pigtail.