Hi everyone,
As you know I just put AFR's on my car, with the Felpro 1101-2 head gaskets.
Which are the 0.039 compressed thickness.
I got the car started and running beautifully but much to my chagrin I noticed coolant leaking out the rear of the passenger's side head.
It was definately leaking out between the block and the head, because when I put my fingernail in between the head and the block coolant would dribble on my finger.
All my bolts were torqued to 70ft/lbs, and I used plenty of ARP thread sealer on the lower head bolts.
I took everything apart again, and looked at the head gasket and noticed no visible damage.
The ARP installation manual specifies a Felpro 1101-1 gasket, which has a compressed thickness of 0.041. The parts store said to use the 1101-2's because they are supposedly stronger.
But my question, would the extra thickness going to be extra insurance against it leaking again? Or should I just get another 1101-2 and try again?
Your advice is greatly appreciated, I'm about to kick my car.
As you know I just put AFR's on my car, with the Felpro 1101-2 head gaskets.
Which are the 0.039 compressed thickness.
I got the car started and running beautifully but much to my chagrin I noticed coolant leaking out the rear of the passenger's side head.
It was definately leaking out between the block and the head, because when I put my fingernail in between the head and the block coolant would dribble on my finger.
All my bolts were torqued to 70ft/lbs, and I used plenty of ARP thread sealer on the lower head bolts.
I took everything apart again, and looked at the head gasket and noticed no visible damage.
The ARP installation manual specifies a Felpro 1101-1 gasket, which has a compressed thickness of 0.041. The parts store said to use the 1101-2's because they are supposedly stronger.
But my question, would the extra thickness going to be extra insurance against it leaking again? Or should I just get another 1101-2 and try again?
Your advice is greatly appreciated, I'm about to kick my car.