who has the most horsepower here?

[muddslide]

just a friendly contest, who has the most horsepower here on pump gas...And what combo set do you have...

 

[TT91]

Quarter Mile: 10.51s @ 127mph
Weight: 3000 pounds
HP: 524 rwhp @ 6000
Torque: 543 ft/lbs @ 4500


Interior Modifications

All options have been stripped
Aerospeed racing seats
5pt harness
8 pt rollcage
Autometer gauges: tach, fuel press, boost, oil press, and water temp.

Exterior Modifications

Saleen body kit
5inch cowl hood
Jade matallic green
tinted 5%


Performance Modifications

DSS 331 Forged Motor
SVO main support
Trickflow Twisted wedge ported heads
Crane 1.6 Roller-rockers
AFM Hi-rev camshaft
AFM powerpipe
Vortech S-trim w/ small pulley
Holley Systemmax upper/lower intake
Vortech Mondo bypass valve
Pete Jackson Noisy timing gears
Aeromotive fuel system
42lb injectors
MSD 6-AL/MSD Boost Retard
MSD Billet distributor
Pro-5.0 shifter
Spec Stage 3 Clutch
World Class T-5
Ford Motorsport aluminum driveshaft
Eaton diff w/ 4:10 gears
Custom chip / dynoed by Mustang Magic

Wheels/Suspension Modifications

Tubular K-member
Tubular A-arms.
M+M C-C plates
Road race springs
coil overs
Subframe connectors
KYB gas-adjusts shocks and struts
Tubular upper and lower control arms
Welds draglites
BFG T/A's
M/T et streets
Welded tourqe boxes

 

[408stroker5.0]

NATURALY ASPIRATED
I know I don't have even close to the most on this board, but just for the hell of it I'll enter my Numbers. I'm going to say 540-560 Flywheel Horsepower (Similar Torque Numbers). I have not had the engine on the dyno but am booked in June to have the car on a chassis dyno so then I will know the exact numbers. 540-560 is a good estimate as I have seen other motors like mine post similar number's with the similar set up.

What we should do is see who has the most Naturally Aspirated HP, and who has the most Forced Induction HP. Yes?????
This should be a good, long thread.

 

[muddslide]

Good idea lets go NA and with power adder.

 

[Idwitheld-1`]

Who has the longest signature?

I'm NA and I have about 1800-2000 In.- Lb of torque at the rear wheels. Coincidentally, its the same torque found in my desktop electric pencil sharpener.

 

[EMW150]

I don't know what mine makes at the flywheel. Like said above I know I'm not the highest either. My engine made 407 (SAE) to the wheels last year with poor cylinder pressure (needed valve job and rings). I rebuilt over the winter and made a few upgrades so I'm hoping for about 425. I have a dyno appointment on the 3rd so we'll see. Naturally aspirated / Pump Gas.

 

[onefaststang]

600 to the ground = about 700-750 at the crank with the loss of a power sucking non-lockup AOD.