One of my buddies and I installed my H&R SS springs this weekend (everything went relatively smoothly). When all was said and done and we were getting ready to throw away the box that the springs came in and sure enough we found something called a pinion snubber(came with the springs) in there that was suppose to be installed as well. My question is, is this something that I really need to install or something i can live without? (I don't really want have go through this whole process again for item that may not even be necessary).
Does this need to be installed with H&R Springs?
- Thread starter NewMStang
- Start date
squeak93
15 Year Member
It helps but You can live w/o it. Its not hard to put on. A simple bolt and nut. Just jack the car up and you can remove the old one.
flstang65
10 Year Member
It's not hard. You don't have to go through the whole process to install just that. The longest part of the whole install will be jacking the car up and taking it back down.
stangnutlx
New Member
1992 2.3LX
New Member
here is the install from MM
http://www.maximummotorsports.com/content/install/pdf/rear_susp/MMPS.pdf
http://www.maximummotorsports.com/content/install/pdf/rear_susp/MMPS.pdf
Guess I should have included a .pdf with my three steps...
lol..well the pics posted above were enough, but i figure i'd say thanks since the guy took the time to post a link.
