View attachment 240919
View attachment 240920
View attachment 240921
Apparently this is a common issue as I came across a prior thread on here. Will this cause any problems? Couldn't really get under there to see after I released the jack but it looks like just the sheet metal was bent. That middle point (last pic) probably wasn't even a jacking point haha didn't realize how soft it was. Just saw the little indentation like most other standard jacking points and went for it until I heard the sound and cringed.
I need some subframes. MM good? Worth the extra $25 for powdercoated?
View attachment 240920
View attachment 240921
Apparently this is a common issue as I came across a prior thread on here. Will this cause any problems? Couldn't really get under there to see after I released the jack but it looks like just the sheet metal was bent. That middle point (last pic) probably wasn't even a jacking point haha didn't realize how soft it was. Just saw the little indentation like most other standard jacking points and went for it until I heard the sound and cringed.
I need some subframes. MM good? Worth the extra $25 for powdercoated?