It's A Race......

Wh will reach the paint booth first...?

  • Chepsk8 / Cobrask8

    Votes: 5 50.0%
  • BBCM / Sally

    Votes: 1 10.0%
  • None of the Above

    Votes: 4 40.0%
  • All of the Above

    Votes: 0 0.0%

  • Total voters
    10
  • Sponsors (?)


I voted for "none"!!!

OMG, I'm still alive!

Been racing Cobrask8 very hard, new roll cage, motor mods, it's just about a full racxe car now! Did 145 on Sat a few times on the front stretch.

BUT................

I do have Winter body work plans, changinf the rear flares on the body. and while it's there, you never know what could happen......

Fritz - I think a bet with a WAGER is in order.....

Cobrask820102.jpg


Cobrask820105.jpg
 
BTW - There is a picture floating around in the internet, I think on the FFR C*bra forum, of my car in a paint booth. so, technically, I have already won this bet!

If you want to pull that crap....Sally was in the paint booth AND was painted in 1995!!! :p:p:p

So........she wants to know, when are you coming over to detail her? ;)
 
I voted "NONE OF THE ABOVE"; because you guys are never gonna be done with your cars...... oh wait - that's me! Yeah but you guys probably will be in the same boat.

But now I'm starting to re-think this; since Fritz now has a pretty strong "Cheering Section". I think I even remember her saying something about getting "proposals on paint".
This one may go to the BBFCM.








OBTW Fritz: Have you explained "BBFCM" and "GCC" to the lady yet?
I think she might be curious........... :rlaugh:
 
more parts to install......

I have sally's new "nose" (GT350R style front valance) and subframe connectors.....
62893d1276547080-its-race-gt350r.jpg

62892d1276546957-its-race-sfc.jpg


The prep work for the subframe connectors is done, just have to do the final fitting and wellding, going to get that and the final weld up of the rocker panel done this week...(I hope!)
 

Attachments

  • SFC.jpg
    SFC.jpg
    141.6 KB · Views: 191
  • GT350R.jpg
    GT350R.jpg
    193.4 KB · Views: 173
I got these from Tinman Fabricators, made specifically for The '65 stang and very simple installation.
First you cut open the end of the front subframes, slide the connectors into the front subframes the conform to the floor pans and meet up with the rear subframes just in front of the rear spring mount.
Two 1/2" holes on either side of hte front rails for spotwelds, weld up the frames.......