With alot of pain and suffering we finally finished the build with alot of $$$$$$ we now have the dyno results it made 505RWHP at 6000RPM's and max torque of 500ftlbs at 3000RPM's and flat right across the top it's an absolute monster to drive. The 2.1 KB was swapped out for a 2.6 KB and with the pulley we are running right now it makes about 13.5 PSI of boost the motor keeps wanting to make power but because it's a stock block we aren't pushing it until i replace it with a Dart block and then i can push it harder but i'm gonna have some fun with it just the way it is for the next couple of years. Oh by the way the intercooler works so good that my dyno pulls repeated 4 more times without any power loss as a result of heat