Search results

  1. M

    carbon canister

    is the carbon canister really necessary. i know for stinger's ic kit he says that you can take it out.
  2. M

    instrument guages

    1)how do you take out the guage cluster ina 91. the chilton says to take out the side switches but i can't figure out how. 2) i put on my af guage and the only thing that happens is there is one rich led that turns on and it doesnt change. the ground and illumination are good and the signal...
  3. M

    springs

    quick but stupid question. i have a chance of buying an eibach prokit but its for a 5.0. will it affect anyting if i put them in my turboford
  4. M

    gauge wiring

    i have a 91lx and i am putting my boost guage in and my question is where did u guys get the illumination wire. ive read on turboford that some took it off the radio but i would rather just get it off the guages. i would rather not pull the cluster so does anyone know which fuse it is so i can...
  5. M

    she lives

    after turbo swap she finally started up. i had fuel issues before and i fixed it by running a wire from the batt straight to the pump and she ran for a little while the first time. Now she dies after a few seconds. my question is about the two sensors on the back of the intake close to the...
  6. M

    few wiring questions.

    my fuel pressure guage is not reading any pressure but i have spark and i know fuel comes out of the line. I have not hooked up the act sensor yet is it possible that this would cause it not to push more fuel. Also i have not cut off the extra connectors that were left from the wiring harness. i...
  7. M

    it cranked

    sooo i tried to crank it today. i was worried there it wouldnt even crank but it did. i have spark and the fuel pump does prime. i smell fuel but none is going to the fuel pressure guage. i have a feeling that i connected the return and other line backwards.
  8. M

    vaf wiring

    egr question im kinda confused at the vam wiring for my 91. the wire that goes to baro sensor, does that go directly from the vam to the baro or do i have to splice in the maf wire also. sorry if im not being clear.-marcin
  9. M

    bigg problem with pins

    i was repinning the computer and the number 5 pin which is supposed to be removed broke off the wire and now is stuck in the plug. is there anyway i can get it out? please help this is in a 91 by the way.
  10. M

    swapped in and troubles

    so i swapped in the turbo engine into my 91 i had a bitch of a time with the motor mounts. i didnt know to use the mustang mounts and it created problems but i figured it out. now i am starting with the wiring and i left a harness on the old engine because i cannot take off the sensor on the...
  11. M

    tfi

    how much does a tfi usually run for. the tiny avenger site has one for 120 dollars. i doubt that they are that much. i hear they burn out easily.
  12. M

    how long will it take

    i have a 91 lx and i have everything reay for the swap. im wondering how long it took you guys to get the car running after the swap. i've heard the engine can be taken out in two hours and im sure the wiring takes the longest. im looking for best and worst case scenerio, experienced and...
  13. M

    elec fan

    i just bought this electric fan. I know I will have to make brackets but my question is how to control it? do I get an on/off switch or a low/high/off switch? Im gonna be running a 94 ranger radiator probably with an npr and stinger piping. http://www.corral.net/forums/showthread.php?t=696309...
  14. M

    swap questions for all you gurus

    a couple of questions about my swap. im getting parts for the swap right now and want to begin when i get everything. i got an 87 motor with a t-3, browntops, gutted upper and lower, ported head bigger valves, centerforce clutch. so far i bought the La3, harness, Npr ic. since the tc engine has...
  15. M

    door latch

    does anyone have a picture how the rod is supposed to hook up to the door handle. i have two rods left one for the key and the other for the handle and i can't figure out which is for the door handle and how it stays on. thanks- marcin
  16. M

    door latch

    just wondering if the door latch for an 88 is the same as the one for a 91 lx does power and non pwer make a diff
  17. M

    just bought my 2.3 have some problems

    the passenger door doesnt lock. The power locks dont work on that door and can't close it manually. Its jammed somewhere. does anyone have any experience with this. What kind of suspension upgrades can i do. I wanna keep the stock shocks and springs cuz they ride nice but the body roll is...
  18. M

    rear sway bar

    whats the best rear sway bar upgrade. should i get one off a gt or buy aftermarket
  19. M

    tranny

    im trying to figure out how to go about my engine swap and the major headache im having is with the tranny. i have a 95 3.8 and i want to put in a 2.3 turbo engine. only problem is that the input shaft in the 3.8 is 7.85 in length and .668 in diameter. but the svo tranny are 7.41 and .59. i was...
  20. M

    merkur turbo

    what are the diferences between the merkur turbos, and the svo's and turbocoupes. i know the tranny is different but will it bolt up to a t-5? does it make an install more difficult? is it a different wiring harness from the svos and turbcoupes? thans marcin
Top Bottom
Back
Forums
Menu