Search results

  1. 5.0TailPipeHump

    No Start After Winter

    So parked the car for the winter with just over a half tank of gas and battery connected, nice day today so i decided to fire it up , well that was not the case. It will turn over till the battery dies but tthat's it, i got fuel pressure to the rails and can smell the gas when trying to...
  2. 5.0TailPipeHump

    Drivetrain 8.8 Rearend Guru's. Identify This Sound

    got some gears installed last year and having trouble identifying a noise from the gears, i get a popping sound and squeak from the rear , i uploaded a video of what's going on here. View: https://www.youtube.com/watch?v=oBaDBtekGXk&feature=autoshare View...
  3. 5.0TailPipeHump

    How To Rotate Driveshaft

    Got a slight vibration on the highway and want to rotate the drive shaft to see if it fixes the issue, recently had some 355 gears go in. Question is do i have to remove the whole shaft to rotate it or can i just remove the four 12 point bolts and still keep the drive shaft in the...
  4. 5.0TailPipeHump

    Driveline Squeak/chirping?

    Need a little help with a noise i got coming form underneath, recently got gears installed Parts installed were Axle bearings axle seals pinion seal shim kit. 355 gears Now i,m dealing with a noise that's driving me nuts. Also just happened today i,m getting a slight knock while coasting at low...
  5. 5.0TailPipeHump

    Tubular Control Arms Help (pic)

    I was greasing up my control arms and used quite a bit of grease, i was expecting grease to start coming out the sides and be good to go, so i took out the bushings and there was grease in there but also a rather large hole going into the tubular part and suspect grease made it way down this...
  6. 5.0TailPipeHump

    After Market Upper Control Arm Rubber Bushing Will This Work?

    Well i ended up going with some after market control arms and don't want to run the uppers with polyurethane bushing but rather rubber , this is my daily driver and have a fear of binding up the rear suspension so rubber would be the choice for me if i can get this to work . I ended up taking...
  7. 5.0TailPipeHump

    Lower Intake Hoses To Heater Core Help

    I just finished up a heater core install and before i had my lines byPassed, i can't remember how they hook up to the heater core , what side does the water pump hose going to the core go on, Passengers side or drivers side? and help or diagrams would be appreciated .
  8. 5.0TailPipeHump

    Antifreeze through the firewall

    Just got back from a drive and got on it some and then i noticed white smoke out my back window , i though on sh!t head gasket but i don't think thats what going on here , i'm leaning more towards the heater core , on the passengers side there,s a small black hole with antifreeze coming out , i...
  9. 5.0TailPipeHump

    My T5 through the inspection cover

    Hey guys , here is my problem , at idle my throw out bearing and fork are wobbling, when the clutch is pressed there is no noticeable wobble in either the bearing or fork, my pressure plate is good and the bearing retainer has low miles om it as it was replaced with a steel one along with a...
  10. 5.0TailPipeHump

    Clutch or engine vibration

    Hey guys i'v been trying to figure this out for awhile now and am in need of your help. I got a used Lsc engine that runs great , got it installed in the fox but now i'v got a wild vibration going on , checked out the balancer and it did have a wobble to it so i got a new powerbond balancer and...
  11. 5.0TailPipeHump

    Oil pressure help!

    Well i got me a used 5.0 lsc engine and runs good, got it installed and am sure i got all wires back to where they were. When i turn the key to the on position my oil gauge rises up but then when i go to turn it over and running it drops to nothing and hits rock bottom. Took out the sender and...
  12. 5.0TailPipeHump

    How to remove my A9L

    Question for yeas, i'm going to be removing the brain of the car and need to know the process or what tools to use. Is there any clips that i should be aware of or nuts that hold it in.
  13. 5.0TailPipeHump

    Pvc off smoke out da oil filler. vid

    Hey guys , wonder if yea can give me any advice on whats going on or whats the next steps to take , oil on #3#4 plugs , check my valve seals and there good but still smokes , as soon as i remove the pvc from the intake i get smoke coming out the oil filler neck but when i re attach it its fine...
  14. 5.0TailPipeHump

    Bad valve seals?

    Started smoking on take off and start up and not as bad when shes been running for 15 mins. Pulled #3 #4 plugs, # 4 being the worst, at idle it does not puff but when i add oil on the vehicle running it will start to smoke , ill give it a rev and ill get some smoke and when she comes down in...
  15. 5.0TailPipeHump

    Ngk spark plugs

    Going to be changing out my plugs and want to try out what ngk has to offer, currently running h/c/i set up and the heads are gt40X heads , right now iv got autolite 2924's in the car . What part # for the ngk am i looking for with these heads and will they be 1 step colder than a stock plug...
  16. 5.0TailPipeHump

    Lincoln Mark VII Lsc ecu

    Wondering if i can use the ecu out of this car in my 93 with out any problems, would it be worth scooping it up and are they identical and wheres the ecu located in these cars? Is there anything else worth taking off of em . This vehicle is at a wreakers and has an ho engine in. Hell i might...
  17. 5.0TailPipeHump

    Pintle cap

    Hey guys , question on what does a pintle cap do , the ones i got on my injectors are cracked and 1 had came right off the injector , would it be bad to run with out one of these caps or what is the purpose of them.
  18. 5.0TailPipeHump

    Help Identifying these codes

    I had got some codes pulled and need some help with a code 94 and 44 with the engine running, i'm using the obd1 code reader but lost the manual, when i performed the test there's also a O on the right corner of the reader on 94 and 44. With the key on engine off iv got a code 67 o ,10, 18c ...
  19. 5.0TailPipeHump

    how to diagnose knock

    Well problem is a have a knock in the engine , i had an ear scope on the motor around the pan area and hear it from under there, the engine has 14 thousand km on her . I was told if i remove 1 spark plug wire at a time and the noise goes away that it would be a busted piston or a...
  20. 5.0TailPipeHump

    Lower Intake gasket pieces

    Hi guys , just wondering what these small pieces that are in the gasket set for , smog? there about an inch long , one is solid and the other has a passage . Heres a link. 1979-95 Mustang 5.0L Lower Intake Gasket, With Large Intake Port, Felpro #1262 Images - LRS wich one should i use.
Top Bottom
Back
Forums
Menu