Search results

  1. 18mustangs

    94-95 Cobra vs GT

    If value is a concern don't modify a cobra as modficiations usually devalue a car unless selling to a fellow gearhead. Tim
  2. 18mustangs

    PICS! Cheap EGR capping and sensor rigging - smog removal

    I just run the Fox EGR setup on my 95GT, it's cleaner and I still have the benefits of EGR.
  3. 18mustangs

    warm weather= death

    Never had a problem with my Aeromotive, and that was running the bigger SN95 FPR on both the stock 95 setup and the 93 cobra setup with Fox EGR on my 95.
  4. 18mustangs

    Autometer Tach Install ?

    I used this tach bracket from UPR in my 95, maybe you could find a way to mount it in a Fox. Mine is held on by the two bolts that hold the HVAC panel to the dash. Tim
  5. 18mustangs

    open breather element ?

    Don't do it, it's a big vacuum leak. How the PCV system works One an EFI engine and some later carburated engines, the PCV (positive crank case ventilation) system draws air from the crankcase into the intake stream and into the combustion chamber where it is burned in order to reduce...
  6. 18mustangs

    PMS Question - Is a VC breather better than a line back to the intake?

    friends don't let friends use breather caps! Here's the write up I did on the subject a while back: How the PCV system works One an EFI engine and some later carburated engines, the PCV (positive crank case ventilation) system draws air from the crankcase into the intake stream and into...
  7. 18mustangs

    SVO side skirts...

    They're made for Borla, but the new Steeda side exit system looks exactly like the Borla system I have.
  8. 18mustangs

    To spout or not to spout?!

    EGR is good You just said it, your 90 GT, it's 94\95s that are really prone to pinging and my 95 pinged like crazy when I capped of EGR and didn't shut EGR off in the computer. I hooked up the Fox EGR when I did the Fox TB conversion and the pinging stopped completely even in the Texas heat...
  9. 18mustangs

    bore of edelbrock throttle body adapter?

    My 94\95 Edelbrock elbow adapter was 70mm, the TFS is 75mm. 58 is the stock fox TB size, so I seriously doubt that is accurate for the Edebrock piece. Tim
  10. 18mustangs

    side exit question

    I run the Borla SVO kit without the skirts and rather like the look. Here are a couple of pics.
  11. 18mustangs

    Foxbody TB Swap Question

    90* bend by the TB. I used the Fox C&L pipe up top and then cute a couple of inches off of my MAC CAI on the top portion and rotated the top portion of the CAI in order to have it mate to the Fox C&L tube. You could go the other way and get yourself a 90* plumbing connector and some ABS piping...
  12. 18mustangs

    no smog pump + stock H pipe = problems?

    True, but he said he has the stock h-pipe not an aftermarket. The stock h-pipe definitely requires the catalyst (air) for the catalytic converters or they can clog and literally choke a car. Heck I hooked up my smog pump again when I removed my o\r h-pipe and put a new BBK catted h-pipe on...
  13. 18mustangs

    FMS 65TB Now High Idle

    Did you clear the computer before installing the TB. Sometimes when you're replacing things it helps to disconnect the batter for 30 minutes before starting the car again. Tim
  14. 18mustangs

    best cam to run with TFS

    89white50, I assumed he would check P\V clearance and take the appropriate steps on a build like that..but I guess I shouldn't assume! :stick: . Personally I'd not run a stge 3 on the street, but I was comparing the specs he threw up with regards to the X cam with 1.7s. QDRHRSE, I'm with...
  15. 18mustangs

    valve cover breather question

    So you've got the crankcase pressure equalization part down just like with a filtered breather cap, but what positively ventilates the crankcase if the PCV is gone? It takes a little suction in order to pull those corrosive vapors out of the crankcase, did you hook any AN lines up to the...
  16. 18mustangs

    TACH WITH MSD COIL QUESTION

    You misread that as I have an Autometer tach and installed it many moons ago. It states if the Tach is hooked up to the coil on a car equipped with an MSD ignition (the box like a 6AL) instead of to the ignition box's tach port then the warrenty is void. Is all you have is an MSD blaster coil...
  17. 18mustangs

    IAC restrictor plate installed!

    I assume that does what this does http://www.steeda.com/store/-catalog/idlebypass.htm only the Steeda part is adjustable? So is the plate smaller than the gasket? Tim
  18. 18mustangs

    injectors size

    If it's running lean when you get on it my first reaction would be fuel pump, are you still running the stock one? BTW, for your current setup 30# injectors are a bit big, you'd probably do well with 24#. Tim
  19. 18mustangs

    best cam to run with TFS

    The TFS stage 2 (224*\232* .542\.563) is comparable with lift to the X303 (224*\224* .542\.542) but has a better exhaust lift (which means more power) and is actually designed for the TFS heads so I recommend going with the TFS cam shaft. And if you want more lift I'd just run the TFS stage 3...
  20. 18mustangs

    valve cover breather question

    Tim, I'm with jason on this one, I don't see why one would benefit from connecting the VCs together as they're both part of the crank case without the connection. I don't recommend the breather, you have a closed PCV system and running an open breather is only one thing...a big vacuum leak...
Top Bottom
Back
Forums
Menu