Search results

  1. M

    A/F Tuning Q + ProM 80mm 24lb datasheet?

    So I looked through all my data and apparently the ProM24 included with the tweecer is not correct? I got the PMAS 24 cal sheet and the results were much better.
  2. M

    K-Member Sheet Metal?

    Attached (not my car)
  3. M

    K-Member Sheet Metal?

    Do they sell that piece of sheetmetal that the k-member connects to? Mine is starting to rust and I would like to replace it. If you look into your wheel well it is that small platform with two nuts bolted to the top.
  4. M

    A/F Tuning Q + ProM 80mm 24lb datasheet?

    I have a quick issue when tuning. It seems anytime I step on the gas, WOT, the car goes extremely rich 8.0:1. Is this because of the MAF or because of something else. I had it tuned well last year but now I am having trouble getting it to stay around 12-13:1 at WOT. My idle is fine at around...
  5. M

    Horn Beeps when going over bumps

    The horn is also looser than I guess it should be. Its sticking out about a quarter of an inch where it is supposed to be so I'm guessing maybe there is a spring or something in there that is bad?
  6. M

    Radio Filter (Where to buy or measure)

    Ok. How can I emulate that? I have a fiberglass hood so i have no hood lining or hood strap.
  7. M

    Radio Filter (Where to buy or measure)

    It's basically whenever I turn the car on the radio goes off. (Not literally) I just get no reception anywhere. Could it be a bad ground? Where are all the radio grounds located?
  8. M

    Radio Filter (Where to buy or measure)

    Does anyone know where I can buy the radio filter for our cars? Mine has been missing for a while and I want my radio back. It's so bad I only can use CDs. Can someone provide a source to purchase? Either that or could someone measure the capacitance of the capacitor so I could just make my...
  9. M

    Horn Beeps when going over bumps

    What is wrong with my horn? I believe it must be in the switch because it is very easy to pull on the airbag area and the horn will beep. Also whenever I hit bumps in the road it sometimes beeps quickly as well.
  10. M

    Carfax please

    Carfax please. Full report if possible. 1J4FA49S81p333312 Email to [email protected] Thank you in advance.
  11. M

    Does anybody know these bolt sizes.

    Thank you. I just need the bolt sizes that go onto the back of the heads.
  12. M

    Who was it had their front clip cut off and replaced?

    Thank you!
  13. M

    Does anybody know these bolt sizes.

    I'm looking for the bolts that hold the crossover pipe from head to head for emissions. Also looking to know if anyone knows the size/threads of the smog pump bolts. Thank you!
  14. M

    Who was it had their front clip cut off and replaced?

    Someone in Massachusetts had a yellow SN95 and had their front end cut off because it was rusting alot and had it replaced with another front clip. Does anyone remember who that was? I am looking for a reputable shop to do this to my Mach1. I don't want to try it myself.
  15. M

    Tire Recommendations needed

    I need a good street/strip tire that will last a while. The car right now has nitto 555r's on the rear (the ones I am replacing). Does anyone have any insight? Also I have 245/45/17s up front. If I got 275/40/17s up back would it look funny? Rims right now are 17x 8 stock. Soon switching...
  16. M

    Emissions and Smog Pump Question

    I took my smog pump off of my car about 2 years ago in working order and now it has been sitting around and I recently had to put it back on but I noticed it is not spinning. I haven't taken it apart yet but do you have any ideas of what it may be? Also does anyone go through emissions with a...
  17. M

    is it normal?

    Rev-Limiter is set at around 7k on these cars. So no. You probably put the distributor back in wrong or your timing is off. Does it feel like you hit a complete wall and all you hear is basically air being sucked in?
  18. M

    GO CHARGERS!!!!!!!!!

    She will be going out on the field with captains for the coin toss I believe. I think the Chargers definitely have some skill. LT is a GREAT running back, and Gates also is a real asset to their team. Plus their defense is known for their interceptions. The only person I am not really fond of...
  19. M

    Which is faster and more fun?

    I did the same thing. I went with the HCI first. Now I wish I went with the blower first. Each time you add a part with the blower on you will feel a much bigger gain. You will really enjoy it this way and you can buy the HCI part by part and put it on instead of spending the money all at once.
  20. M

    PLEASE HELP I HAVE A BIG PROBLEM....

    Did you take out your distributor recently? This could also be caused by a distributor being off one tooth or an incorrectly timed car. Also check if the bolt came loose that is holding it still.
Top Bottom
Back
Forums
Menu