Search results

  1. 93PONY

    3.8L 2000 traction control...

    i got the same problem, happened when i replaced the radio. what would cause it?
  2. 93PONY

    wont rev past 3000rpm?

    checked it out, everything looks good, do u think my ecus gone south?
  3. 93PONY

    wont rev past 3000rpm?

    ok i have a 1993 mustang. it wont rev past 3000rpm's, it will hit it and fall flat on its face. my exhaust is really black. ran codes and got a few sensors that came up. replaced them still have same problem. so far timing is dead on, replaced fuel pump, fuel filter, fue pressure regulator, iac...
  4. 93PONY

    iv got fuel, got spark, no start. why?

    got it running it starts with mass air unhooked, and runs rough, and dies if you give it too much gas. do i have a vaccume problem or a fuel pressure problem?
  5. 93PONY

    iv got fuel, got spark, no start. why?

    getting there ok so heres what i got. when i unplug the mass air, it starts up, but runs kinda rough. i plugged mass air back in while running, improved a little but still rough. so i let it sit and idle for about 1/2 an hour. went back out and pushed the gas a little, and it just died. would...
  6. 93PONY

    iv got fuel, got spark, no start. why?

    still nothing! ok so heres what iv got. replaced the tps, iac, mass air meter, coil packs, spark plugs (twice), fuel pressure regulator, and fuel filter. and still nothing. this is really starting to p!$$ me off! it cranks over and if i hold the gas pedal it sputters like its going to start...
  7. 93PONY

    iv got fuel, got spark, no start. why?

    like the title says, my 93 2.3 wont start. i have fuel and i have spark. the crank sensor is fairly new, less than a year old. it just cranks over and wont do anything, right before this happened it ran really rough and had really black exhaust, so i turned it off. since then no go. im stumped...
  8. 93PONY

    turbo swap help!

    hello, im about to pick up a 88 turbocoupe with an auto trans. i plan on putting it into my 93 mustang, which also has an auto trans. will the turbocoupe trans work in the mustang? or is there any way of making the mustangs work. i dont want to change it to stick so if thats your answer dont...
  9. 93PONY

    new problem

    tried a brand new batt. and got same problem, do you think its the solinoid? and the sound just comes from under the hood. i just need to get it running so i can get it to my fatherinlaws garage to do my turbo swap, i have everything ready to go except for the exhaust but im not to worried about...
  10. 93PONY

    new problem

    hello my 93 still wont start, now when you turn the key it just makes a rapid clicking noise. has my starter died or is it my altenator? i tried to jump it at the solinoid and got the same results so i have ruled out the ignition switch. please help i need to get this thing back on the road asap.
  11. 93PONY

    cranks but no start!

    found the problem. its the mass air sensor. i unpluged it and it started up but ran really rough. so i pluged it in and the car died. tried to start and got nothing. unpluged it again and started right up. i noticed the plastic has a crack in it so im assuming it got water in it and fried it.
  12. 93PONY

    cranks but no start!

    tried it, checks out fine. would the ignition control module cause this, or mabey even the iac? its been pinging under acceleration, but i figured it was because of the cold. it tries to start but just shutters and won't start. running out of ideas here.
  13. 93PONY

    cranks but no start!

    thanks ill try that, i just changed that sensor about a year ago, do you think it could have went bad already?
  14. 93PONY

    cranks but no start!

    well the other day it snowed really bad and since then my car wont start. it just cranks over and sputters realy bad but thats it. i changed the plugs about 2 weeks ago. i pulled them all today and the smelled of gas so im getting fuel, i replaced the coil packs, put gas in it, checked all...
  15. 93PONY

    spark knock!

    i have a 93 n/a 2.3 with the same problem, it didnt start until it got really cold outside, can it be sucking in too much cold air? i would really like to fix this as it is an annoying/embarassing sound, and would really like to know whats causing it.
  16. 93PONY

    what size adapter

    what size adapter do i need for an aftermarket water temp gauge? all the ones that came with it wont work. they are too big or too small. its a mechanical sunpro water temp gauge. also my electric fuel level gauge reads backwards, it is hooked to the factory wires, why is it doing this?
  17. 93PONY

    need help with fuel sender

    just like the title says. my factory gauge will not read accurate because the previous owner put white face gauges in and put all the needles on wrong. so im replacing with aftermarket stuff. well my fuel gauge is reading backwards, how can i fix this without spending alot of cash. i hooked it...
  18. 93PONY

    wire color

    searched with no luck. what color is the gas gauge wire?
  19. 93PONY

    exhaust smell with heat

    ok thanks, i have one of those smooth aftermarket cowl covers on there, do you think that might be causing it?
  20. 93PONY

    exhaust smell with heat

    its definatly exhaust, i just upgradeed my exhaust but if there was a leak i woul smell it all the time. but i only get it when the heater/blower is on, its enough to make ya feel all goofy (not good). where does it suck all the air from ill start from there
Top Bottom
Back
Forums
Menu