Search results

  1. N

    speed cable bolt size

    bolt doesnt tighten just falls out the hole not sure its a dorman 1/4"-20x3/4 hex head cap screw if that helps
  2. N

    Question about IAC

    flip it upside down. works for me. it runs better on my car like that
  3. N

    speed cable bolt size

    i went and got bolt size 1/4 -20x 3/4 and its to small and falls out the hole. its for a stock t5 trans. this is what bolt size there saying to use
  4. N

    speed cable bolt size

    what is the bolt size to the speedocable the part that goes in the trans and holds the cable in the trans. mine is gone
  5. N

    86 bumper rivets

    what size rivets to use on an 86 mustang front bumper
  6. N

    mustang computer help

    got it at a junk yard i thought i pulled it from an 89
  7. N

    mustang computer help

    what computer do i have e7sf-12a650-c1a
  8. N

    f cam

    i already have a b or an e cam not sure which one. so i thought of getting a f cam. just wanted to know if there was anything else i needed to put an f cam in
  9. N

    f cam

    u need anything else for a f cam to be installed for a 91 mustang. i saw a video and it said to install new lifters or something. i thought u could just put one in and be done. what else would i need
  10. N

    mustang length and width

    what is the lenght and width of a 86 mustang need for winter storage wanted to get prices
  11. N

    egr simulators

    switch it to mass air
  12. N

    egr simulators

    dont think my check engine light even works dont know if does anything or not
  13. N

    egr simulators

    does anybody know about egr simulators they suppose to trick the computer into thinking egr is hook up. they plug into the egr harness seen them on ebay dont know if they really work
  14. N

    msd harness extender 6al box

    not sure how to solder but it cant be that hard. i can always add wire to it and make the wires longer
  15. N

    msd harness extender 6al box

    does msd make an extension harness. i put my msd box under the cold air intake and the wires barley make it to the coil. the wires run infront of the battery. im using the msd one wire hook up at the coil and want the wires behind the battery.
  16. N

    emission tab tad sensor

    nope got rid of all of it there are lines vacuum and other lines going into the firewall and i cant see where there going so tommorrow i take all the extra junk off
  17. N

    emission tab tad sensor

    do i need these tab and tad sensor i dont have any emission so i dont know if i take them out if it will hurt anything
  18. N

    powermaster alt pos bolt need help

    i have a 100 amp alt powermaster now when i first hook it up the power wire was on the top side of the alt. but when i look at it, and bolt it up the power wire is at the bottom of the alt the small bolt housing on top the long bolt housing on the bottom. i could of sworn the pos wire is on top...
  19. N

    no start tfi module maybe i dont know

    could i have burnt out the tfi module. i had a ground wire fire the small one attached to the battery post. fix it went and bought a new solenoid cause i broke the other by over tighten the bolt on the post. now the rpms will move up and down and crank but wont fire over. it will crank slow...
  20. N

    electric fire need solenoid wire diagram

    so the starter is grounded on the neg side of the solenoid
Top Bottom
Back
Forums
Menu