Search results

  1. MikeR351w

    88' 5.0 HO/5spd in 91 4cyl/auto

    I am not sure. I had a shop near town do the wiring. I think they ran a wire from under the seat and bypassed it to the relay under the hood.... Sorry I can be more help!
  2. MikeR351w

    Fuel issue: 92 LX Vortech V1 w/wideband gauge

    I got the bar graph to read further by using the menu on the gauge. Now it is capable of going up to 20.0. So now it reads 16.5 at idle and it goes down to 13-14 at WOT. I disconnected them because I never had them with the car. The harness is missing too... When I get the other o2 sensor...
  3. MikeR351w

    88' 5.0 HO/5spd in 91 4cyl/auto

    I performed this swap as well. I did an 87 2.3L to a 92 5.0. For you, the dash harness should be swapped as well. The stock 91 gauge cluster probably wont work for your swap for a variety of reasons. Some of them being your airbag, the speedometer and a different gauge configuration. I...
  4. MikeR351w

    Fuel issue: 92 LX Vortech V1 w/wideband gauge

    Hello, I have a 92 LX 5.0 with an auto trans. About 130k. Mods for engine only are as follows. Edelbrock Perf RPM II intake 38lb injectors w/80mm mass air meter and 65mm t/b Anderson FMS intake w/k&n filter 8lb blower pulley H-Pipe w/no cats Shorty headers Engine timing is at 14deg...
  5. MikeR351w

    Installing Kenwood deck in 87 LX, w/6speaker setup...

    Already finished my project, but thanks for the advice. Ill put pics up tonight if I can. I did put in the 4" speakers and it was a pain in the but! I did a check and all 6 speakers work and sound great. I also checked with the tweeters, which I am still waiting to install and they sound...
  6. MikeR351w

    Installing Kenwood deck in 87 LX, w/6speaker setup...

    Hello, I have an 87 LX Mustang and I am finally getting rid of the factory tape player. My car originally came with a 6 speaker factory setup with the factory amp behind the stereo on the hump. I am in the process of removing the dash and I am halfway done. I already removed the radio &...
  7. MikeR351w

    Supercharger Tuning Question

    Ill get some o2 sensors and hook them up. I have no starting issues or driveability issues other than some bucking during decel when coasting to a stop without my foot on the brake. I have heard that this could be due to my engine running rich, which would then explain that problem... Ill...
  8. MikeR351w

    Supercharger Tuning Question

    Thanks for the info FIVEOHBLOW. I will drop down to the 3.15 first and see if I get more boost. As I dont have $900 to spend on a PMS unit to tune it at home, I do want to put that on before I get it dyno'd. Also, I will drop the timing to 10deg before the dyno as well. I will also invest in...
  9. MikeR351w

    Supercharger Tuning Question

    I currently have the 3.33" on now. Any suggestions on which one I should switch too????
  10. MikeR351w

    Supercharger Tuning Question

    I have the following pulleys 2.95" 2.75" 3.15" Which one? The 3.15???
  11. MikeR351w

    Supercharger Tuning Question

  12. MikeR351w

    Supercharger Tuning Question

    I eliminated my smog pump and have a H-pipe with no Cats. Thats why... I do have the bung plugged up so I would then assume that the A/F gauge would come with a threaded insert to place it into the exhaust....
  13. MikeR351w

    Supercharger Tuning Question

    For a wideband A/F ration gauge, dont I need my o2' sensors hooked up? I dont have them anymore...
  14. MikeR351w

    Supercharger Tuning Question

    Hello, I have a 93 LX 5.0 with 125k on the motor. I currently have the following modifications: -Vortech V-1 Supercharger w/9lb pulley -Anderson FMS Power Pipe that goes into fenderwell -80mm Mass air meter -38lb Lucas Injectors -255lph fuel pump -NO FMU -Edlebrock Performer RPM II...
  15. MikeR351w

    Fuel pump cut-off switch - HELP with simple question!

    Great! Thanks for the info. I am now using a 20 amp switch. How much amperage goes through the switch??? I am guessing not more than 10 amps for the pump..
  16. MikeR351w

    Fuel pump cut-off switch - HELP with simple question!

    I have a 93 LX 5.0L. I park it in a bad area. I recently wired in a fuel pump cut-off switch about two weeks ago. I wired it in between the positive (12v) going to the relay. This morning, the fuel pump was stuck in the priming mode and would not shut off. I turned the pump off by using...
  17. MikeR351w

    Vortech V1 in 93 LX - AOD question

    I have a 93 LX 5.0 with an AOD trans. I recently put a Vortech V1 on it and its a beast! I have now noticed after hammering on it that the trans tends to skip (or VERY quickly shift out of second) second gear and go right to third. Is this normal???? It also does it when I got from "1" to...
  18. MikeR351w

    Help wiring fuel pump cut off switch...

    Ran a two way switch with three prongs. Hid it under the dash. It is awesome! Only cost $5.00! Cheapest anti-theft system ever. I am considering disabling the ignition too.....
  19. MikeR351w

    Help wiring fuel pump cut off switch...

    I have a 93 LX 5.0 hatch. I want to wire in a cut off switch to the fuel pump relay. I bought a 30amp switch which has three prongs. Is this switch rated at 30amps, too high or too low for the power that will run through it. Also, do I ground it or just run both hot wires to the different...
  20. MikeR351w

    White junk in Oil Separator:Supercharged 5.0

    Weird question: I have a 93 LX 5.0, with a V-1 Vortech Supercharger on it. I have an oil separator in between the PCV valve and the intake for blow by. The last 500 miles I have noticed that there is white junk, almost sap like substance in the catch can. What is this????? Smells a bit like...
Top Bottom
Back
Forums
Menu