Alright, so long story short, I bought a block second hand after I ventilated my last one at VIR. I'm on the process of putting everything back together and found this hole on the driver's side, circled in green. Its stripped out and I'm pretty sure I'll have to drill and tap it to stick a new...
Looking for recommendations for my rotating assembly for my 89' HO 302. Just got back from the machine shop and it was bored .30 over. i am on a somewhat tight budget but i also dont want to cheap out. Willing to use same crank and i have a E cam that going to go in the car. Its a fairly stock...
Hello everybody, first post on here so please excuse me if this is on the wrong section. I was tearing down my 86’ 302 tonight, when it was taken part so that it was only the bottom end with the water and oil pumps still attached, I turned it upside down to let the oil drain out and these two...
Hello all, I am in the midst of replacing my 4.6 motor on my 96 with a new one I purchased online. (The new one isn't off a '96, it was manufactured in '99 and doesn't have pi heads so I'm thinking it might be off an explorer or something.)I have the old one pulled and am preparing the new one...
Swapping the head gasket and there's slight pitting on the block. I've cleaned it up a pretty decent amount but I'm not too sure if this will be an issue as far as sealing or not. I went around the surface with a straight edge and .006 & .003 feeler gauge (same tolerance for the heads) it all...