carburetor

Hello all, I have an 88 Fox mustang GT with 302 roller motor. Has about 180psi of compression in all 8 cylinders. I was sick of the old efi so I carb swapped it. I put an Edelbrock rpm air gap intake, redone E7 heads, stiffer comp cam valve springs, a b303 cam, roller tip 1.6 rockers, and a...

Hey everyone, I noticed the wingnut on my air filter was loose so I cranked it down and snapped half the stud right out of the carb. What would be my best approach to get the rest of the stud out of the carb? Any advice/help/discussion is appreciated!

Hey guys, new to the forum. Ive followed this forum for 2 years without making a account and have always been able to find useful information however, this time I need more in depth help. Im carburetor swapping my 1995 gt and i have the carb mounted, intake swapped, fuel pump deleted in the...

Hello everyone, New to this website here. Owner of 79 Thunderbird with Ford 302 and 2150 carb. No place to ask a question, and I know thunderbird and mustang shared the same engine. So, im here. Here is my problem. Original everything, Motor craft 2150 carb. The carb is reman installed week...

Hi, I have been looking everywhere for the right carburetor for my 1968 I6 Mustang. I found a re-manufactured one on summit racing (link) that says it is compatible but I am a little apprehensive buying it as the photo appears slightly different than the one that is currently on the car now...

Hello all, I am thinking about purchasing a edelbrock 600 cfm carburetor (part number 1406). I'll be bolting it to the stock intake manifold that came with the original ford 302. The original carburetor was a motorcraft 2150, not sure if that helps. Anyways the question is if I need any gaskets...

Hello all, Im wanting to rebuild my 2 barrel carburetor on my 1970 mustang coupe with a 302-2V. I'm having trouble identifying the carb. On the carb it says it's a motor craft and it looks like the original. But I'm not sure if it's an Autolite 2100 or a Motorcrafr 2150 carb. Do the rebuild...

Hi all! Just put a new distributer in, and my '67 Vert runs super-smooth! However, when I take my foot off the gas, the idle drops so low that I stall most of the time - especially at stop signs. Is this more than likely just a simple idle adjustment on the carb? I'm hesitant to change...

Ok so i have an 88 GT and want to throw in a blue print engine with 390hp. The only problem is, its carbuerated but can be fuel injected, but it did say not compatible with stock fuel injection. So i looked at some websites and it said my car is speed density efi. It said i needed to convert to...

Hi all... Totally new here and I'm totally stumped. I have a 66 mustang with a 289. It was running great and then about a week ago I went to drive it and it started missing really hard under load when I would step on the gas. The next day it wouldn't start at all. I check the fuel - no...

Hi everyone, I referenced the thread on here regarding what is necessary for converting a fuel injected 94 Mustang with a 302 to a carbureted setup (see here 94-95 CARB SET-UP HELP!!!! | Mustang Forums at StangNet ). They mention that a throttle cable from a 79-85 work best (years that carbs...