Selling this used but freshly(11/21) machined Manley 190350 crank.
I purchased it with the intent of building a shortblock for my boosted 2v. Decided to switch platforms and sell my car so I no longer need it.
Machine work was done by Ohio Crankshaft for the previous owner.
Asking $550 OBO...
Hey guys, I was in the final stages of putting an on3 turbo kit on my 04 mustang GT. Then a leakdown and compression test showed that I have some pretty bad rings in cylinders 3 and 6. So instead of tuning I want to build the engine. My goal is somewhere around 800whp. I want to keep it...
A buddy of mine and I are dropping the 4R70W trans on his auto 02 Mustang GT. We got the exhaust, starter, drive shaft, and bell housing bolts off no problem, but we made a big screw up and we didn't remove the torque converter bolts mating up to the flex plate. We started to drop the trans...
I have an 03 roush 4.6L NA car, only mods done to it are CAI, Accufab 70mm TB and intake plenum, and exhaust. It threw a code last week for cam position sensor because it would backfire on start ups so I replaced that. I got a new ac system installed today, Just picked it up from the shop and on...
So my mustang has been running wonderfully the past couple months since its last problem. Anyways I'm having some trouble with it now.
When I last turned off the car I left the windshield wipers in the on position, when I went to crank it, the windshield wipers came on for a split second, heard...
1997 mustang v6
Yesterday after work I had driven about 5 miles and then when I was getting on the highway (current speed 75) and I see my rpm gauge drop instantly to zero, I tap my cluster then take it out of gear to see if its running, its not. I turn the key off then back to the run position...
Hi guys,
I've just installed a 2014 engine into my 2011 GT and I think my ECU has a tune on it, only worked it out when it would only run with a big JLT intake and wont run with a stock one. I want to retune the ECU to a tune that I know and trust. Now with that, can I just flash the ECU...
Shattering noise coming from the engine not sure if its rod knock or the bearings. It happens when I press on the accelerator, the higher the rpm goes the louder the shattering sound gets.
So im in the process of rebuilding my 302 for my fox body. The engine is out on a stand and Ive been replacing various things here and there over the past month or so. When the engine was in the car and I fired it up, the harmonic balancer would wobble a fairly decent amount although the crank...