leak

  1. T

    2001 3.8 Coolant Leak Near Intake

    I have coolant pooled up under my upper intake manifold near my passenger side valve cover. I recently replaced my thermostat and have a coolant sensor that I still need to put in. I can't tell if it's leaking from a cracked manifold or if it's a bad intake gasket. Which is more likely and how...
  2. T

    Ac Coming Out Defrost Vent

    Whenever i turn my air on, it only works coming out of the defrost vent regardless of where it's set. I've read up and found a common source to be a vacuum leak. My mechanic looked at it this morning and said that if it was a vacuum leak he would be able to hear it and the engine would run...
  3. LUKAStheGUNNER

    Fuel 2001 Mustang - Check Gas Cap Light Problem

    (2001 GT AUTOMATIC) So a while back, when driving i noticed my "check gas cap" light came on the dash on the opposite side of where the check engine light is. Well i kinda figured it didnt mean anything as far as a damper to performance. I ignored it but later i decided to buy a new gas cap to...
  4. S

    Water Soaking Passanger Side, Cant Find Answer In Other Posts

    I have a 2006 V6 convertible. I had a ton of water in my passenger side, and through this forum figured out the problem was a clog in the piece behind the windshield, causing water to come out behind the glove box. I cleared it out, and it was fine. Now, a week later, I looked over and both the...
  5. N

    Help Convertible Leak

    98 gt convertible leak. I have finally managed to find it but don't know what to do now. There are 4 small hole tears located in between the 2 layers of material in the bottom left and bottom right corner of the rear window(the holes are on the first layer of material closest to the interior of...
  6. SadbutTrue

    Oil Pressure Sender Issue On Roller 351

    I'm actually a classic owner but the engine is a roller 351/408 stroker, so i figured I'd ask here. I've been having a pretty annoying issue with my oil pressure sender/adaptors. I transitioned from an older style 351w (early 70s), and tried to re-use my old oil pressure setup. Though I'm not...