Hi from Europe! First of all I want to say sorry for my English. My 1967 289 engine has been machined and fully rebuilt. It also has a new E-street topend kit from Edelbrock.
The problem. is that oil pressure is around 6PSI at hot idle. Bearings are +0.10 and new, oil pump is fresh new +20PSI...
I have a '93 (as best I can tell) 5.0 engine and computer which I have installed in my '66 Mustang. Can I disconnect the electronic oil pressure sender completely and replace it with a flexible stainless braided line for my mechanical gauge and leave it disconnected or is there a required signal...
So I am having issues with my oil pressure, noticed while driving home that it was dead empty, as i was pulling over it jumped back up to normal range and from there it began to go back and forth. I did have my timing chain guide break and i just replaced that today, driving the car and noticed...
I was replacing the oil pressure sender on my 1989 mustang 5.0 when I accidently knocked a plate off this hole. It was very badly attached by a previous owner and I have no idea what belongs here. I found pictures of what goes here but I have no clue what it is or does. I’ve been running my...
Hello everyone, I am new to the forum, and ashamed to say, an extreme novice in auto repair. In the past, changing the oil was about as deep as I would dig. Now that I am a little older, and have a little toy to tinker with, I'm willing to take on some more repair. I have a 1998 Mustang GT...
HELP!! Okay guys so I'm trying to install an Oil temp sensor signal in my 2014 Mustang GT WITHOUT going through the sandwhich adapter route. I cannot seem to find anything on the internet.
So I decided to look under the car myself and seeing maybe I can find a port or existing outlet that...
I was driving my wife home when my GT just stalls. I tried to start the car but it wouldn't. I notice my oil gauge was in low, which is weird because I got it serviced a month ago. So I put oil in the car and it started up but now I hear a clicking noise and my car isn't running normal. Please...
Hey guys! I got my GT40p heads on and got the car started and everything. Everything seemed good till the test drive. That's when the oil pressure dropped from the usual 40-45 to 20-25. The car went from having power to none at all. Today I went out to look around it to start the car I have to...
Hello everyone!
New to stangnet.com, but have been browsing around for a while. :-)
Just traded for my first mustang - a 1998 Cobra clone with a 4.6L. Absolutely love the mustang. It's the most enjoyable vehicle I've ever owned. I'm hooked for sure.
I'm currently working on fixing a few...