shifting issue

Hey guys, I have a 2002 mustang gt that has become increasingly hard to shift. The clutch is annoyingly heavy (to the point where it is challenging to feather it) and shifting the gears takes a ton of effort. I installed a new adjustable clutch cable kit a couple of months ago, which made the...

I have a 2003 mustang gt auto with 108k miles, I installed a fresh crate motor to find my transmission shifting through first and second wonderfully but when it is suppose to shift to third it downshifts to first and I’m wondering if it could be anything other then a bad transmission I did a...

So I recently got a 2012 5.0 and in the higher rpm's when trying to shift, the pedal would stay in until the rpm's get lower, it works perfectly if im not raising the rpm's or trying to "race it" but its happening everyday and is getting annoying. What do you guys think i should do? Master...

I got an automatic ‘66 convertible not too long ago. It’s starts and runs good most of the time, but occasionally won’t start. But if you put it in neutral and push it forward or backwards and put it back into park, it then will start. Occasionally, it will start but not shift into gear, or...

Thanks for taking the time for anyone who does. I’ll cut to the chase. I have a 2003 mustang gt with the 5-speed manual. I just recently replaced my throw out bearing which seemed to go just fine. After the job it drove fine for one whole day, then it became hard to get into gear. Long story...

1995 GT. Just replaced the clutch with a RAM HDX street/strip clutch and PP. Throw out bearing is Ford Racing and Pilot bearing is too. Flywheel was resurfaced at a shop. After everything was done, the clutch would grab on the floor. I installed a Ford Racing adjustable cable and got it to the...

I recently traded for a 93 2.3 auto but did not get a key. Mainly a parts vehicle so I just hot wired it to test everything. I connected the red with green tracer to the yellow wire then touched the pink and white wire to them and it started right up no problem but when I pull it down in gear...