I just started on my install of the 03 front control arms, 00 cobra r tie rod ends and C springs. So far i've run into a couple of problems especially since my impact gun is broke so I couldn't take the top strut bolt off... just took the the bottom strut bolts out so the strut is still there but really isn't in the way. How do I get the balljoint nut off without an impact gun? Also the same for the tie rod ends...
i've done plenty of searches and even though i found some install guides none of them were very thorough. Most skipped steps and none of them mentioned anything about the ball joint nuts or tie rods.
i've done plenty of searches and even though i found some install guides none of them were very thorough. Most skipped steps and none of them mentioned anything about the ball joint nuts or tie rods.