• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

1/4 times

  • Thread starter Thread starter cj_scarletty
  • Start date Start date Jul 8, 2008
C

cj_scarletty

Member
Mar 10, 2008
31
0
6
Madison N.C.
Jul 8, 2008
#1
  • Jul 8, 2008
  • #1
what kind of 1/4 times can i expect in my 97 GT with pulley's and a 99 cobra tranny and Steeda Tri-axx shifter? I'v never had a mustang before. I just trying to get an Idea of what I will run.
 

BurningRubber

10 Year Member
Dec 6, 2004
1,865
24
58
Jul 8, 2008
#2
  • Jul 8, 2008
  • #2
High 14's if you are a good driver.

Your car is still basically stock. Pullies help a very small amount, but every little bit counts.
 
C

cj_scarletty

Member
Mar 10, 2008
31
0
6
Madison N.C.
Jul 8, 2008
#3
  • Jul 8, 2008
  • #3
what kind of improvment would A 100 shot of nitrous give with slicks?
 

98COBRA281

10 Year Member
Nov 24, 2007
1,348
30
59
Port St. Lucie, Florida
Jul 8, 2008
#4
  • Jul 8, 2008
  • #4
i remember the first time i went to the track.... i was talking so much $hit,then i felt stupid when my best time was a 14.9@ 96 with a 2.9 60' and i had 373's, cia, ud pullies and exhaust, i only had my liscens for 3 weeks
 
J

justinschmidt1

Member
Jun 15, 2005
349
0
16
Jul 9, 2008
#5
  • Jul 9, 2008
  • #5
really depends on your driving skills and how the car runs....Ive seen mid to even low 14s out of a 5 speed NPI with a good driver.

I wouldnt expect any better than high 14s/low 15s though
 

BurningRubber

10 Year Member
Dec 6, 2004
1,865
24
58
Jul 9, 2008
#6
  • Jul 9, 2008
  • #6
100 shot and slicks would realistically net a mid-lower 13 second pass.

I reccomend getting used to the car in its stock form first, then once you are comfortable with it start modding.

Jumping straight into nitrous is not the best of ideas if its a new car to you, alot to look into.
 

Stan Weiss

Member
Dec 8, 2006
347
2
16
Philadelphia, PA
Jul 9, 2008
#7
  • Jul 9, 2008
  • #7
100 shot and slicks should run 13.2 to 13.3 with a good driver.
 
H

hskrs10

Member
Dec 21, 2004
35
1
6
Nebraska
Jul 9, 2008
#8
  • Jul 9, 2008
  • #8
My stock 98GT with CAI ran a 14.9 I was very disapointed.
 
You must log in or register to reply here.

Similar threads

9
1997 gt Starts then dies a few seconds after.
  • 97orange
  • Aug 13, 2026
  • SN95 4.6L Mustang Tech
Replies
5
Views
290
SN95 4.6L Mustang Tech Aug 17, 2026
97orange
9
J
Engine 4.6 Running rough at half throttle
  • jake411
  • Aug 3, 2026
  • SN95 4.6L Mustang Tech
Replies
5
Views
289
SN95 4.6L Mustang Tech Oct 20, 2026
DangStitches
D
Hinge Roller repair kit
  • Rdub6
  • Aug 5, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
1
Views
164
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 5, 2026
gkomo
D
Will 2023 (Non-Handling Pack) Mach 1 Wheels Fit A 2013 Mustang GT OK?
  • dmw_4814
  • Oct 27, 2026
  • 2010 - 2014 Specific Tech
Replies
0
Views
104
2010 - 2014 Specific Tech Oct 27, 2026
dmw_4814
D
S
4.6 spitting o-rings out of 2 injectors
  • skidad
  • Sep 30, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • 2 3 4
Replies
78
Views
2K
1996 - 2004 SN95 Mustang -General/Talk- Nov 4, 2026
skidad
S
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?