MSD put a new pickup sensor in my distributor.
When I went to reinstall it, I put the balancer to TDC.
When I install the distributor, the rotor ends up a little before the #1 plug mark or a little after.
Is this normal? Do I just move the distributor slightly after it's seated, so that the rotor lines up?
I have Ford Racing GT-40 motor with 7000 miles on it.
Thanks
When I went to reinstall it, I put the balancer to TDC.
When I install the distributor, the rotor ends up a little before the #1 plug mark or a little after.
Is this normal? Do I just move the distributor slightly after it's seated, so that the rotor lines up?
I have Ford Racing GT-40 motor with 7000 miles on it.
Thanks