1998 gm olds intrigue

chrismillion · Aug 5, 2004

i know that this is a mustang site, but i just installed a waterpump on this car and after i crunk the car about one minute later it threw a code of "camshaft position sensor". i was careful not to move the crank fearing that i would throw it out of timing while i was doing the procedure. so any info would be great cause it is giving me a headache! again i know this isn't a stang, but you all know i have one.

P.S i hate side ways motors, they are a pain in the rear!

chrismillion · Aug 5, 2004

an hour later

HISSIN50 · Aug 5, 2004

what size motor? did you have to mess with the timing belt to do the pump? the cam timing might not be spot on, if so (off by a tooth).
good luck.

89 blue lx · Aug 5, 2004

sorry man but it is a stang site maybe there are some olds ppl here somewhere?

chrismillion · Aug 5, 2004

89 blue lx said:
sorry man but it is a stang site maybe there are some olds ppl here somewhere?

i said that right off the bat!! i know that , cause i'm on here every night. it's my religion

chrismillion · Aug 5, 2004

HISSIN50 said:
what size motor? did you have to mess with the timing belt to do the pump? the cam timing might not be spot on, if so (off by a tooth).
good luck.

3.8L V6

mo_dingo · Aug 5, 2004

So I assume the timing belt turns the water pump on that car. You need to re-do the cam timing.
Scott

chrismillion · Aug 5, 2004

it's a serpentine belt. one belt like our cars have.

AznStanger3v · Aug 5, 2004

well, everything should be good in the hood then. you cant really throw off timing with just touching the serp. belt. i have no clue why that code would come up. post a picture of the engine so we can get a better feel for it.

Joes95GT · Aug 5, 2004

Does the waterpump work like a Mustang where you don't have the remove the front cover to replace the water pump? Does the car run alright?

Joe

chrismillion · Aug 5, 2004

Joes95GT said:
Does the waterpump work like a Mustang where you don't have the remove the front cover to replace the water pump? Does the car run alright?

Joe

i never had to take mines off. i took the pulley off the W/P then i took off the powersteering pulley so i could get to a certain bolt for the w/p. afterward i put the w/p on and put the pulley back on for the powersteering and i put the w/p pulley back on. next i put the belt (one) back on. i put water in the radiator and bleed the cooling system with the bleeder valve. after that i crunk the engine and waited for the thermostat to open up and top the radiator off again. after that i put the top back on the radiator and 1 minute later the motor surged and the service engine light came on. i immediatly went to AutoZone(they treat me like a king there cause i'm there spending money all the time)and they put it on the scanner and it quickly put out "Camshaft Position Sensor" it didn't say replace it. i looked for a book on GM olds intrigue, but there wasn't any. i went to Advance Auto Parts and they didn't have one either. do anyone know where the sensor is located? i need help! i'm going to jump back down on it in the morning, so i need some insites. thanks

chrismillion · Aug 6, 2004

an hour later

HISSIN50 · Aug 6, 2004

i dont think a car will run with a bad cam sensor (it is like our pick ups, in the dizzy). it should be on one end of the cam or in the middle. read the manual and find it. check the electrical connector.

for fun, go over every place you worked to make sure you did not forget to reconnect an electrical connector or any lines, etc. ive done that quite a few times.
good luck.

iluv95stangs · Aug 6, 2004

I work at a chevy dealer. It may be the cam sensor got coolant on it, or maybe you bumped the plug, or the ignition module could be bad, or a million and one other things. If you can get the code # for me I may be able to e-mail you a trouble tree to follow and find the problem. Too much in that particular circuit to diagnose.

chrismillion · Aug 6, 2004

thank you all , but i got a GM certified master mechanic to solve the issue. i think i did get coolant on the sensor.

1998 gm olds intrigue

chrismillion

chrismillion

HISSIN50

"How long does it take to get help in here?

89 blue lx

chrismillion

chrismillion

mo_dingo

chrismillion

AznStanger3v

Active Member

Joes95GT

New Member

chrismillion

chrismillion

HISSIN50

"How long does it take to get help in here?

iluv95stangs

New Member

chrismillion

Similar threads

1998 gm olds intrigue

"How long does it take to get help in here?

Active Member

New Member

"How long does it take to get help in here?

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency