2.3 trubo

[herbie911]

hey guys i have an 88 mustang 2.3 5speed i have the complete engine out of an 88 trubo coupe , ecm wire harness what else would ineed to complete the swap???? :

 

[Red_LX]

downpipe...that's about it really. Do you have the VAM? Sounds to me like you're pretty much set.

 

[mr_woodster]

leave out the wiring harness and just do a pin change (3 wires) using your stock 2.3 harness.

Did you pick up the turbocoupe (if it was a 5 speed) flywheel/clutch/pressure plate? Id recomend it, i had to change to the turbocoupe setup (bigger than n/a) becuase my na clutch started slipping under load.

 

[Shawneebear93]

How much work is it to change a clutch?

 

[BELL]

on your back in the drivway about 4hrs. in a shop on a hoist with the right tools about 45min to an 1.5hrs

 

[99blkcobravert]

You need to upgrade the fuel pump to handle the larger injectors.

 

[SVOconvLX85]

All the stock fuel pumps are the same. Upgrading to a bigger one is recomended though.