• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

$2000! & I want to upgrade my brakes,

  • Thread starter Thread starter downsouthman1
  • Start date Start date Jan 15, 2004
  • 1
  • 2
Next
1 of 2 Next Last

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 15, 2004
#1
  • Jan 15, 2004
  • #1
clutch, shifter, & gears. What should I get?
 

stangman

15 Year Member
Jul 10, 2003
2,690
10
69
in a 3 bed, 2 bath
Jan 15, 2004
#2
  • Jan 15, 2004
  • #2
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 15, 2004
#3
  • Jan 15, 2004
  • #3
That helped a lot.
 

stangman

15 Year Member
Jul 10, 2003
2,690
10
69
in a 3 bed, 2 bath
Jan 15, 2004
#4
  • Jan 15, 2004
  • #4
it didn't make sense until i saw the "fixed" thread
 

Beau

Founding Member
Jan 29, 2000
3,050
0
0
San Diego
Jan 15, 2004
#5
  • Jan 15, 2004
  • #5
get 13 inch brembo brakes. and a king cobra clutch.
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 15, 2004
#6
  • Jan 15, 2004
  • #6
1990StangLX said:
get 13 inch brembo brakes. and a king cobra clutch.
Click to expand...
I actually intend to upgrade all 4 brakes & the brembo kit is only the fronts.
 

FastRedPonyCar

Founding Member
Apr 7, 2002
1,678
4
39
I pee sitting down...or do I?
Jan 16, 2004
#7
  • Jan 16, 2004
  • #7
don't waste your money on the brembo kit unless you're going to be road racing. The cobra or bullitt brakes are fine for most people. You're really not going to notice a big difference between the cobra brakes and the brembos unless you repeatedly slam down on the brakes time after time. The cobras will fade quicker than the brembos will.

There are a couple of places like www.diskbrakesrus.com that sell kits. You can get the full front swap kit for like $300

Don't even bother with the back brakes. They barely do anything to begin with.

As for the remaining $1700, you could get king cobra clutch, 4.10's, tri-ax, a set of tokico illuminas, and the Dragon intake plenum with 75mm TB.

That's what I would do if I was in your shoes.
 
D

DerekStangGT

My package is in the mail!
Feb 18, 2003
1,068
0
36
Jan 16, 2004
#8
  • Jan 16, 2004
  • #8
FastRedPonyCar said:
don't waste your money on the brembo kit unless you're going to be road racing. The cobra or bullitt brakes are fine for most people. You're really not going to notice a big difference between the cobra brakes and the brembos unless you repeatedly slam down on the brakes time after time. The cobras will fade quicker than the brembos will.

There are a couple of places like www.diskbrakesrus.com that sell kits. You can get the full front swap kit for like $300

Don't even bother with the back brakes. They barely do anything to begin with.

As for the remaining $1700, you could get king cobra clutch, 4.10's, tri-ax, a set of tokico illuminas, and the Dragon intake plenum with 75mm TB.

That's what I would do if I was in your shoes.
Click to expand...

i agree. unless your gt sees regular road track time, youre not gonna notiice a big difference. however, in terms of spending the remaining money i would buy:

gears-4.10 or 3.73 depending on future plans
King Cobra Clutch
tri-ax
dragon plenum
c&l maf
timing adjuster
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 16, 2004
#9
  • Jan 16, 2004
  • #9
Well what I'm looking @ right now is a set of 3.90 Pro 5.0 Gears for $180, Steeda Tri-Ax Shifter for $162, & a SPEC II clutch for $300, all off Stangnet.com. I'm still looking at the brakes & I have to leave some $$ for labor since I can do some stuff myself. But as I'm not gonna bust my own rear-end open or replace my clutch, I may as well have whomever does those do the brakes & shifter as well. I'll let yall know exactly as I order as I will order today & I'll come back here before I order.
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 16, 2004
#10
  • Jan 16, 2004
  • #10
I'm looking @ diskbrakesrus.com right now. What benefit is there if you get nickel plating or powder coating?
 
D

dhjones

Founding Member
Aug 22, 2001
734
0
0
Tidewater, VA
Jan 16, 2004
#11
  • Jan 16, 2004
  • #11
Check baer brakes also. I like mine alot.
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 16, 2004
#12
  • Jan 16, 2004
  • #12
For a grand total including shipping of $1767.95 I ordered Pro 5.0 3.90 Gears, Steeda Tri-Ax Short-Throw Shifter, Ford Racing SPEC II Clutch from Stangnet.com & Saleen Brakes 13" Cross-Drilled & Slotted Front Rotors with white powder-coated calipers & silver powder-coated rotors with Steel-braided brake lines & some brake pads & same for the back except 10.5".
 

hognutz

New Member
Nov 12, 2002
1,940
0
0
albany, oregon
Jan 16, 2004
#13
  • Jan 16, 2004
  • #13
I would not spend the money on brakes yet. the brakes on our cars are pretty good. they may not look flashy or have huge rotors but In a single stop situation they are fine. go find some road test and look at the 60-0 times. I think a gt is around 135ft wich is very similar to the cobra. now if you did 10 consecutive stops the cobra would do better but I never have to do that. my vote would be gears, cams(comp 270 or vt mild n/a), plenum, sct tuning software. this should give you full control over the car and give you 30hp. with more power and the lower gears would be night and day. save the brake upgrade for later. if you are dead set on brakes look at baer.com also.
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 16, 2004
#14
  • Jan 16, 2004
  • #14
I did check out baer.com but they ran too much. My brakes are shot so I have to replace them anyway. & rather than spend $300 on the stocks I'll just upgrade.
 

hognutz

New Member
Nov 12, 2002
1,940
0
0
albany, oregon
Jan 16, 2004
#15
  • Jan 16, 2004
  • #15
downsouthman1 said:
For a grand total including shipping of $1767.95 I ordered Pro 5.0 3.90 Gears, Steeda Tri-Ax Short-Throw Shifter, Ford Racing SPEC II Clutch from Stangnet.com & Saleen Brakes 13" Cross-Drilled & Slotted Front Rotors with white powder-coated calipers & silver powder-coated rotors with Steel-braided brake lines & some brake pads & same for the back except 10.5".
Click to expand...

I would really look at that brake purchase. I only say it because I have looked into it as well. when I looked at road tests the best 60-0 I found between saleen, roush, corbra, bullit was the bullit at 127ft. granted differnt drivers. Maybe I just did not find the right data. everything else should be a good investement. if you are doing it more for looks then that is cool.
 

mity2

I like Pro3 and all I got was this crappy CT.
Jul 24, 2003
2,872
3
48
StateCollege PA
Jan 16, 2004
#16
  • Jan 16, 2004
  • #16
so far the best brake set up for the money I think that I found...

baer crow system
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 16, 2004
#17
  • Jan 16, 2004
  • #17
I am not so much getting it for performance, but my brakes are shot & I need new ones anyway. Since I need new brakes I may as well upgrade. Here are the scales. $300 to replace pads, turn rotors, replace rotors that are possibly warped, & not increase braking performance at all. Or $1091 to replace pads, upgrade to better-cooling rotors, upgrade calipers, upgrade to steel-braided brake lines, & somewhat improve braking performance. You decide.
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 16, 2004
#18
  • Jan 16, 2004
  • #18
hognutz said:
I would really look at that brake purchase. I only say it because I have looked into it as well. when I looked at road tests the best 60-0 I found between saleen, roush, corbra, bullit was the bullit at 127ft. granted differnt drivers. Maybe I just did not find the right data. everything else should be a good investement. if you are doing it more for looks then that is cool.
Click to expand...
Remember also that since the Roush, Bullit, Cobra, & Saleen have similar braking systems the biggest thing in the Bullit's favor is lack of weight. A car that weighs less will always slow down quicker w/ the same brakes.
 

hognutz

New Member
Nov 12, 2002
1,940
0
0
albany, oregon
Jan 16, 2004
#19
  • Jan 16, 2004
  • #19
I guess the point I was trying to make was the 60-0 on the cobra and saleen were not really better than the gt. As long as you are happy with the purchase I say great. I have not seen 100-0 data. I would asume repeatablity would be better with the upgrade do to the rotors. I understand what you are saying but I do my own brake works so for me it is like $150 vs 1k. I need rationlize why I spent the extra $850. I was all set to do this when I put on my h&r's, and bilsteins this month. I am just going to do a brake job and paint my calipurs.
 

downsouthman1

Member
Dec 16, 2003
643
0
16
Texas
Jan 16, 2004
#20
  • Jan 16, 2004
  • #20
I understand about rationalizing $850. I usually do my own work on my car & will do the brake install w/ a buddy when they come in.
 
  • 1
  • 2
Next
1 of 2 Next Last
You must log in or register to reply here.

Similar threads

S
New guy- first Stang- I love it !!
  • smid333
  • Mar 22, 2026
  • The Welcome Wagon
Replies
5
Views
187
The Welcome Wagon Mar 23, 2026
smid333
S
H
Strange steering/brake issue
  • Haxmaster
  • Jun 2, 2026
  • SN95 4.6L Mustang Tech
Replies
1
Views
92
SN95 4.6L Mustang Tech Jun 3, 2026
squeak93
J
Wheels-Tires Need Some Help - Brakes Upgrade/Wheel fitment
  • jaygee15
  • Dec 8, 2025
  • Fox 5.0 Mustang Tech
  • 3 4 5
Replies
81
Views
3K
Fox 5.0 Mustang Tech May 6, 2026
AeroCoupe
Brakes FOX BRAKES ISSUES
  • PonyGTrider
  • Jan 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
53
Views
2K
Fox 5.0 Mustang Tech Jan 31, 2026
Mustang5L5
3
B&m hammer shifter c4 question
  • 387lx
  • Mar 18, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
4
Views
298
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 19, 2026
387lx
3
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?