You're not that far from Fox Lake either. They do very good work and build some great heads. They do engines as well!!
Fox Lake Power Products
6060 Dalton Fox Lake Road
North Lawrence, Ohio 44666
Phone: (330) 682-8800
Thanks!!
Riley
I wouldn't put longtubes on a stock motor. They are just too expensive for what little improvement they provide to a stock motor.
I wouldn't put longtubes on a stock motor. They are just too expensive for what little improvement they provide to a stock motor.
Long tubes are good for around 20 hp give or take. At this point the install cost is minimal. I'd recommend them as long as emissions arn't an issue.
I totally disagree with that statement. Even if the gains were minimal at best right NOW I am sure he is like every other car guy out there and has future plans for the car. But since it has been proven time and time again that long tubes just simply make more power than the stock loggers, it is a GREAT time for him to install them as the motor will be out anyway. 15 horse is 15 horse. In our cars, it doesn't take much to make a nice gain. Plus it will make every other mod he does in the future that much better.
Do the Lt's if you can afford them!
Look at the ship date on the edelbrocks. I'd honestly go bbk if your looking at budget.
You get what you pay for. I personally think bbk's quality has gone down A LOT in the past years. (compared a friends 351 swap headers from 8-10 years ago with a set I bought last year, wow, the new ones were nasty. Took 2 hours of grinding to clean up the inside welds on the ports). Anyway, headmans seem to be good and I don't know much about the pypes yet.
Honestly, when I comes to LT's I would only put SLP or kooks on my car. Again, you get what you pay for. SLP is pricy, but a damn quality header.
i just cant justify shelling out 900 bucks for headers
Oh I understand completely. But I'll tell you what. When you spend 400 bucks on headers just to realize they are too cheap to seal. And you try to seal them 4 times, each time dropping the K-member, you'll wish you had spent 900 bucks the first time. I would get the quality headers or not do it at all. just my .02
my motor is going to be completely out of the car when i install the headers....
Yep, this time around. Trust me, I'm not trying to force any opinion on you, just trying to share some of my experiences. Good luck!
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?