i guess i would like to know more of where i can get the parts and what years i can pull the axels and rear drums off of? would it be easier just to convert the rear to disc while im at it? What vehicle and year can i pull the front spindles off of? I have a 88 LX 5.0
5 lug conversion ?s
- Thread starter Modular2v
- Start date
mustangjoe87
Member
ok i am buy part to do this over christmas so i may be able to help a bit.
ebay is prolly your best bet for parts ive gotten some great deals
you can use 94-95 for the front and have the same track width, or 96+ has an 8mm wider track. theses are off a 98.
View attachment 519933
for the rear you can either buy a set of ford axles fox length or 94-98 have a 3/4inch wider track. do not use 99+ axle shaft they are 1.4inch wider not good
but you can use the brakes from them all 94-04. these are off a 96.
View attachment 519934
or you can go with ranger drums and drivers side axles shafts only.
if you go disc you must swap master cylinders from a 3 to a 2 port and gut the stock proportioning valve and use a knob style. this web site will tell you everything you want to know. http://www.svo73mm.cjb.net/ good luck
ebay is prolly your best bet for parts ive gotten some great deals
you can use 94-95 for the front and have the same track width, or 96+ has an 8mm wider track. theses are off a 98.
View attachment 519933
for the rear you can either buy a set of ford axles fox length or 94-98 have a 3/4inch wider track. do not use 99+ axle shaft they are 1.4inch wider not good
but you can use the brakes from them all 94-04. these are off a 96.View attachment 519934
or you can go with ranger drums and drivers side axles shafts only.
if you go disc you must swap master cylinders from a 3 to a 2 port and gut the stock proportioning valve and use a knob style. this web site will tell you everything you want to know. http://www.svo73mm.cjb.net/ good luck
mustangjoe87
Member
mustangjoe87
Member
Similar threads
