I've taken apart my engine which I'm converting to carb and discovered this eccentric installed:
I believe it's a 2-piece unit from which someone took the outer part and slapped it back in the engine, am I wrong? There's "2A" stamped on it and the pin is not going through.
So, the question is, can I run my pump on it? The outside diameter is 59.6mm (2.35"), does anybody know what OD should it have for a pump to work properly? If I'd know the correct dimensions, I can probably fabricate a new eccentric to solve this problem. I'm in the middle of Europe so i can't go for a junkyard hunt. )
Thanks for your insights!
I believe it's a 2-piece unit from which someone took the outer part and slapped it back in the engine, am I wrong? There's "2A" stamped on it and the pin is not going through.
So, the question is, can I run my pump on it? The outside diameter is 59.6mm (2.35"), does anybody know what OD should it have for a pump to work properly? If I'd know the correct dimensions, I can probably fabricate a new eccentric to solve this problem. I'm in the middle of Europe so i can't go for a junkyard hunt. )
Thanks for your insights!
Last edited: