9" out of a 66-67 Bronco bolt in?

[kwkenf]

Just a quick question. Will a 9" rear end out of a 66-67 Bronco bolt into a 67 Fastback?
I'm checking on the length.
Thanks,

 

[D.Hearne]

No, the spring pads are flipped from a Stang. Should be narrower than a Stang rear too.

 

[68restoman]

Check the Ultrastang website, I believe that it's the same width as 65-66 so would be narrower, perches would need to be relocated and they have the truck wheel pattern...

68Restoman

 

[latamud]

It won't bolt in, yes it is same width as 65/66. The bronco rear mounts under the leaf springs. Perches are $20 at any 4x4 shop. I had my axles redrilled for $40 at a machine shop. Mine came with a 4.11 and Detroit locker out of a junk yard 66 Bronco.

 

[kwkenf]

Check the Ultrastang website, I believe that it's the same width as 65-66 so would be narrower, perches would need to be relocated and they have the truck wheel pattern...

68Restoman

Thanks...Yes there are a few mods (as some have mentioned) that need to be done before it will work.

http://www.ultrastang.com/Rearinfo.asp?Page_ID=1

Lots of great info on that site.

Thanks again.