- Oct 21, 2009
- 162
- 0
- 17
Who cares about who said what.....let's be adults here. I'm more willing to trust HISSIN50 over ANYone on this forum particularly to the fact that his answers have solved all my problems....Though I'm not going to doubt your knowledge of the subject, but I did buy a new MSD TFI module for my MSD Super Billet Distributor and it didn't solve my problem. It wasn't the solution in my case, though it could have been....that's auto troubleshooting for you.
HISSIN- It will start up as in the usual rpm jump when it starts but the part where the rpms drop back down it dies. So really it doesn't hold long enough to idle. Also I'm still confused on how to "check the ECT" I have a Aftermarket Mechanical Gauge and it runs no hotter than 185-190*.
HISSIN- It will start up as in the usual rpm jump when it starts but the part where the rpms drop back down it dies. So really it doesn't hold long enough to idle. Also I'm still confused on how to "check the ECT" I have a Aftermarket Mechanical Gauge and it runs no hotter than 185-190*.