95 mustang longtubes

1995 GT · Jun 20, 2010

Was about to order a set of bbk long tubes! was wondering if the 94-95 have a egr bung. Sine I have deleted my EGR and smog pump system! Do the 79-93 have a egr hook up on the passenger side will the fit a 95 gt? What about the h or x pipes?

NinJa_FLiP · Jun 20, 2010

no, the bbk longtubes for the 94-95 dont come with the egr bung.. no emissions testing in pa? from what ive seen, the h and x pipes that fit the foxbody 5.0's will work on 94-95's as well.. but as far as longtubes for the fox bodies, they wont fit the 94-95 without some modifications..

1995 GT · Jun 20, 2010

In Pa as long as u don't drive over 5000 there is no imission tests, but doesn't matter my mechanic will run a car the passes in it's place!!! thank for the help nice to no don't have to have an ugly cap on the nice new headers! What the best plan for the smog pump tube on the mid pipe?

revhead347 · Jun 20, 2010

Actually, the new BBK longtubes do come with the EGR bung. I just put a set on a customer's car not long ago. You need to get a cap to cap it off if you don't have an EGR. 93"- headers won't fit unless you have a 93'- transmission and bellhousing setup.

Kurt

1995 GT · Jun 20, 2010

That's gay! Too bad

red1995gts · Jun 20, 2010

They deff. come with a bung.

Last5.0 · Jun 21, 2010

My '94/5 ceramic coated BBK longtubes have an EGR bung. The headers aren't new, I've had them for about 5 years. They clear a Fox bell/tranny setup (TKO600 and SFI bell) just fine, but don't know if there's any problems the other way around. I haven't had a set of BBK Fox headers to compared the differences between them and SN95 primary tube routing.

.... I used to have MAC longtubes and the drivers side primary tube routing was different between the fox and SN95 and the SN95 model headers would run right up against the clutch cable where it entered the bell, but the fox primaries were routed differently and it wasn't a problem.

NinJa_FLiP · Jun 21, 2010

woah.. wth was i reading then? lol.. everyone told me if i went with longtubes, i would need to get an egr bung welded to it.. that works better for me then.. lol

ProKiller · Jun 21, 2010

fox long tubes will work but you need a fox bellhousing and clutch fork.

revhead347 · Jun 21, 2010

ProKiller said:
fox long tubes will work but you need a fox bellhousing and clutch fork.

You need a fox tranny too. The fox transmission input shaft is 5/8" shorter, and the bellhousings are not interchangeable. The reason I say "fox style" transmission, is because the TR-3550/TKO is setup for a Fox body, with a fox body clutch fork. Since a lot of guys upgrade to these transmissions, it helps to know you can run Fox headers after the upgrade.

Kurt

revhead347 · Jun 21, 2010

Last5.0 said:
My '94/5 ceramic coated BBK longtubes have an EGR bung. The headers aren't new, I've had them for about 5 years. They clear a Fox bell/tranny setup (TKO600 and SFI bell) just fine, but don't know if there's any problems the other way around. I haven't had a set of BBK Fox headers to compared the differences between them and SN95 primary tube routing.

.... I used to have MAC longtubes and the drivers side primary tube routing was different between the fox and SN95 and the SN95 model headers would run right up against the clutch cable where it entered the bell, but the fox primaries were routed differently and it wasn't a problem.

The problem is when it goes the other way around. The Fox headers are narrower, and hit the clutch fork on an SN.

Kurt

Last5.0 · Jun 21, 2010

yeah the clutch fork on a SN is like at the 9 o'clock position while a fox setup is at the 7 o'clock position when looking from the back of the car.

95 mustang longtubes

1995 GT

New Member

NinJa_FLiP

Member

1995 GT

New Member

revhead347

Apparently my ex-husband made that mistake.

1995 GT

New Member

red1995gts

New Member

Last5.0

Active Member

NinJa_FLiP

Member

ProKiller

revhead347

Apparently my ex-husband made that mistake.

revhead347

Apparently my ex-husband made that mistake.

Last5.0

Active Member

Similar threads

95 mustang longtubes

New Member

Member

New Member

Apparently my ex-husband made that mistake.

New Member

New Member

Active Member

Member

Apparently my ex-husband made that mistake.

Apparently my ex-husband made that mistake.

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency