96 4.6 Pi Intake And Cam Install

MileHi91LX · Apr 6, 2017

I have a few questions before undertaking this project. Any help would be greatly appreciated.

1) Could someone please direct me to the most comprehensive DIY thread on this topic?
2) Is a tune required to make the car run right after this upgrade?
3) I'm also planning a cold air install at the same time. I should've put #2 after this!
4) Is it worth purchasing the AFM tool to do this install?

Thanks in advance everyone!

squeak93 · Apr 6, 2017

https://www.stangnet.com/mustang-fo...-important-threads-newbies-here-first.583369/

There are multiple threads in here. Start reading and ask questions where needed.

Yes a tune will be needed in order to fully benefit from the new found air flow. Yes it will run on the npi tune but I strongly recommend a tune.

A cold air is really for looks, the stock air box tends to be as good as a quality cold air (only ones that take air from the fender, do NOT do a engine bay kit.

I just tear it all down (take the front cover off) as it gives you the chance to replace old gaskets etc.

Good luck.

MileHi91LX · Apr 11, 2017

I've located the PI intake and cams. Should I also buy the plenum? He has the TB for sale too, but I believe the 96 and 01 both had a 65mm, so I shouldn't need his TB? Is that correct?

COramprat · Apr 19, 2017

You can buy those parts but not really needed.

squeak93 · Apr 25, 2017

Plenum and tb are the same.

96 4.6 Pi Intake And Cam Install

MileHi91LX

Member

squeak93

MileHi91LX

Member

COramprat

...I can take it. I think.

squeak93

Similar threads

96 4.6 Pi Intake And Cam Install

MileHi91LX

Member

squeak93

MileHi91LX

Member

COramprat

...I can take it. I think.

squeak93

Similar threads

Privacy & Transparency

Privacy & Transparency