Here is a better link.
http://www.mustangmonthly.com/howto/30079/
Or you could get one of these cup holders. I got one, they are a little clunky, but not too bad.
http://secure.50resto.com/product1.cfm?SID=1&Product_ID=1959&Category_ID=757
http://www.mustangmonthly.com/howto/30079/
Or you could get one of these cup holders. I got one, they are a little clunky, but not too bad.
http://secure.50resto.com/product1.cfm?SID=1&Product_ID=1959&Category_ID=757
You can swap out the consoles easily or do the mod in that article. It's simple to do also and should only take about an hour or so. I got my cup holder on ebay.
You can cut out the hole with a dremel but measure and trim carefully. You can always keep shaving off more but it sucks to try and add more back on so be patient.
You can cut out the hole with a dremel but measure and trim carefully. You can always keep shaving off more but it sucks to try and add more back on so be patient.
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7930867539&category=33695 theres a tan one
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7930891380&category=33695
black one ^
now someone find me a grey one
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7930891380&category=33695
black one ^
now someone find me a grey one
You could always try stang parts. That's where I got my 98 center console and if i remember correctly it only cost me like $60.00. The website is www.stangparts.com
http://www.stangparts.com/products/partpic.cfm?TypeID=21&ID=2263&Page=1&ShowSpecials=FALSE
oi! not worth $100 to me.. I'll keep checking ebay
oi! not worth $100 to me.. I'll keep checking ebay
I cut my 94 console to fit the 98 cupholder. I have actually done this twice. The 98 cupholder is a different color black than our black, but it's not really noticable. It's the dark charcoal color. There is also a little rubber mat that goes in the bottom of the cupholder.
I used a dremel and a utility knife to cut the console. Take little bits out and test fit a lot. Be especially careful of the little rectangular notch in the rear. If it's just a bit too big, it will be seen when the cupholder is installed. When you are done, you will love it!
Rick
I used a dremel and a utility knife to cut the console. Take little bits out and test fit a lot. Be especially careful of the little rectangular notch in the rear. If it's just a bit too big, it will be seen when the cupholder is installed. When you are done, you will love it!
Rick