A/c clutch replacement

Yes... you need not remove the compressor or disharge the system. Pull the serpentine belt. Pull the fan shroud and possibly the radiator depending on how much room you have with the radiator you have installed. Remove the A/C pulley then use a set of reversible snap ring pliers to take the snap ring off that's holding the clutch assy in place. Put the new one on, and put whatever you had to take apart back on and whola!

Shouldn't take you more than an hour or so. Make sure you have the snap ring fully seated.
 
PuterAmI said:
Or, pull the compressor. Just a few bolts and you can swing it so that one would not have to take out the radiator.

No, no brushes or such. It uses a field coil to energize.

Hmmmm.... what is the going rate of anti-freeze vs. R-12 these days? :rolleyes:

Edit: NM... I get what you're saying. You'r talking about removing just the bracket mount bolts and not the service lines.