• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

ACT sensor bad?

  • Thread starter Thread starter mac7290
  • Start date Start date Oct 20, 2005
M

mac7290

Member
Aug 5, 2004
28
0
6
Phoenix, Arizona
Oct 20, 2005
#1
  • Oct 20, 2005
  • #1
getting a code 54, replaced with a new ACT sensor and still getting code. measured the voltage and got 4.72 from one wire. reference wire i'm guessing. and .10v from the other wire. all the info iv've read .60 is the lowest it should be. the temp here is high 70's and the engine temp was at 160 when i tested it. the resistance check seemed good though. took two readings about 10minutes apart and the ohms were between 4k & 5k. which should be acurrate according to the charts i've seen on here just the voltage is'nt checking good. i'm thinking the voltage should of been around 1v. thanks for any help.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Oct 21, 2005
#2
  • Oct 21, 2005
  • #2
Here's some ACT help, some of which you may have already seen...

Code 54 – ACT sensor out of range. Broken or damaged wiring, bad ACT sensor. Note that that if the outside air temp is below 50 degrees F that the test for the ACT can be in error.

Check the resistance of the black/white wire to battery ground. If it is less than 1 ohm, it is good. If it is more than 1 ohm, the black/white wire has bad connections or a broken wire. Always take resistance measurements with the circuit powered off.

Then check the resistance of the ACT sender located in the #5 intake runner on most 5.0 stangs.

ACT & ECT test data:

The ACT & ECT have the same thermistor, so the table values are the same
To access the computer, remove the passenger side kick panel. You will need to remove the plastic cover over the wires. A safety pin may be used to probe the connections from the rear.

Pin 7 on the computer - ECT signal in. at 176 degrees F it should be .80 volts

Pin 25 on the computer - ACT signal in. at 50 degrees F it should be 3.5 volts. It is a good number if the ACT is mounted in the inlet airbox. If it is mounted in the lower intake manifold, the voltage readings will be lower because of the heat transfer. Here's the table :

Use the ground point next to the computer for voltage measurements.

68 degrees F = 3.02 v
86 degrees F = 2.62 v
104 degrees F = 2.16 v
122 degrees F = 1.72 v
140 degrees F = 1.35 v
158 degrees F = 1.04 v
176 degrees F = .80 v
194 degrees F = .61

Ohms measures at the computer with the computer disconnected, or at the sensor with the sensor disconnected.
50 degrees F = 58.75 K ohms
68 degrees F = 37.30 K ohms
86 degrees F = 27.27 K ohms
104 degrees F = 16.15 K ohms
122 degrees F = 10.97 K ohms
140 degrees F = 7.60 K ohms
158 degrees F = 5.37 K ohms
176 degrees F = 3.84 K ohms
194 degrees F = 2.80 K ohms

See the following website for some help from Tmoss (diagram designer) & Stang&2Birds (website host) for help on 88-90 wiring


http://www.veryuseful.com/mustang/tech/engine/images/88-91eecPinout.gif

 

Attachments

  • 88-91eecPinout.gif
    167.1 KB · Views: 420
You must log in or register to reply here.

Similar threads

S
Electrical Stumped No Start...
  • sydhawk
  • Oct 28, 2025
  • Fox 5.0 Mustang Tech
Replies
8
Views
300
Fox 5.0 Mustang Tech Oct 29, 2025
sydhawk
S
8
Electrical Crank-no start ... no spark ... no injector pulse, was it something I did? (redux)
  • 85gtCOBRA
  • Oct 28, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
578
Fox 5.0 Mustang Tech Oct 29, 2025
85gtCOBRA
8
R
93 LX 2.3 Trouble codes 53, 85, 21 help
  • Rickshaw302
  • Apr 15, 2025
  • 2.3L (N/A & Turbo) Tech
Replies
17
Views
634
2.3L (N/A & Turbo) Tech Apr 18, 2025
AeroCoupe
S
Fuel ‘88 GT Runs Rich Cold — Fixes Itself When I Unplug Sensors (ECT, MAF, O2, etc.)
  • Sufarry
  • Nov 6, 2025
  • Fox 5.0 Mustang Tech
Replies
12
Views
882
Fox 5.0 Mustang Tech Nov 9, 2025
Mustang5L5
SURGING IDLE / NO IDLE CHECKLIST FOR 1999–2004 MUSTANG GT (4.6L 2V) - Work In Progress
  • Noobz347
  • Aug 30, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
934
1996 - 2004 SN95 Mustang -General/Talk- Aug 30, 2025
Noobz347
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?