Hey Steve,
Glad to see another satisfied C&L customer......... Lee Bender has got to be one of my favorite Mustang people in the world.
We purchased a C&L 80mm MAF kit about two years ago for about $260.00. They didn't offer any of the downstream plumbing (ie- plenum) for an '01 Cobra- just the MAF, the big-azz K&N filter, and a heat shield...... took about 15 minutes to yank the factory setup and install everything.
With only the factory MAF setup, a DiabloSport 4-bank chip and a set of Steeda UDP's we dynoed at 286.0 RWHP/ 293.7 TQ with a JerryW laptop tune- up in HP from an original baseline pull of 273.3 RWHP/ 303.3 TQ.
or about 13 RWHP increase above baseline..... not too bad.
We then made a pull with the C&L in place of the factory MAF.......... absolutely NO other changes......... and promptly recorded a 299.0 RWHP/ 305.1 TQ sheet, while the A/F reading held b/w 13.8- 14.1 at WOT....... an ADDITIONAL 13 RWHP. So we picked up 26 RWHP and a couple of ft. lbs. of torque with 3 bolt-ons that certainly seem to work very well when used in the proper combination....... and we haven't even TOUCHED the exhaust ............ yet.
I always felt that the C&L stuff worked magic on the 4v motors........ glad to see that somebody has figured out the 2v setup, too..... GOOD JOB !!
I know that lots of folks are Pro-M advocates, and that's fine............ whatever works for YOU- do it. But I'd think twice before judging the C&L stuff as second-best......... to ANYBODY, 'coz you just might be judging wrong.
Glad to see another satisfied C&L customer......... Lee Bender has got to be one of my favorite Mustang people in the world.
We purchased a C&L 80mm MAF kit about two years ago for about $260.00. They didn't offer any of the downstream plumbing (ie- plenum) for an '01 Cobra- just the MAF, the big-azz K&N filter, and a heat shield...... took about 15 minutes to yank the factory setup and install everything.
With only the factory MAF setup, a DiabloSport 4-bank chip and a set of Steeda UDP's we dynoed at 286.0 RWHP/ 293.7 TQ with a JerryW laptop tune- up in HP from an original baseline pull of 273.3 RWHP/ 303.3 TQ.
or about 13 RWHP increase above baseline..... not too bad.
We then made a pull with the C&L in place of the factory MAF.......... absolutely NO other changes......... and promptly recorded a 299.0 RWHP/ 305.1 TQ sheet, while the A/F reading held b/w 13.8- 14.1 at WOT....... an ADDITIONAL 13 RWHP. So we picked up 26 RWHP and a couple of ft. lbs. of torque with 3 bolt-ons that certainly seem to work very well when used in the proper combination....... and we haven't even TOUCHED the exhaust ............ yet.
I always felt that the C&L stuff worked magic on the 4v motors........ glad to see that somebody has figured out the 2v setup, too..... GOOD JOB !!
I know that lots of folks are Pro-M advocates, and that's fine............ whatever works for YOU- do it. But I'd think twice before judging the C&L stuff as second-best......... to ANYBODY, 'coz you just might be judging wrong.