All parts needed for gear change?

Spaded_Z

New Member

May 25, 2004

35

0

0

Jul 13, 2004

#1

• Jul 13, 2004

• #1

My rear end needs to be rebuild and I'm going to be tossing in a 4.10.
So, I think that my list of parts to purchase is:

-FRPP 4.10 gears

-Ring and Pinion install kit #3 (KIT INCLUDES PINION & CARRIER SHIMS, CRUSH SLEEVE, PINION SEAL, PINION NUT, RING GEAR BOLTS AND COVER GASKET, PINION GEAR AND CARRIER BEARINGS, AXLE SHAFT BEARINGS AND AXLE SHAFT SEALS)

-23 tooth speedo gear

-Clutch pack kit w/friction modifier

Am I missing anything or do you see anything that needs to be corrected?

 

B

BEATNGU

Founding Member

Jun 22, 2002

346

0

0

WestCentral, NY

Jul 13, 2004

#2

• Jul 13, 2004

• #2

You got a clutch pac kit? $60, comes w/ the friction mod
Get one, your stock pacs are most likely toast. While your at it, add the next thicker shim it comes w/ the kit. You wont be disapointed after the break in.

 

Spaded_Z

New Member

May 25, 2004

35

0

0

Jul 13, 2004

#3

• Jul 13, 2004

• #3

BEATNGU said:

You got a clutch pac kit? $60, comes w/ the friction mod
Get one, your stock pacs are most likely toast. While your at it, add the next thicker shim it comes w/ the kit. You wont be disapointed after the break in.

Click to expand...

Right on.

 

3

300hpWRX

Banned

Dec 18, 2003

20

0

0

Aug 11, 2004

#4

• Aug 11, 2004

• #4

Do you need the pack kit if your rear end is still intact?
Where's a good place to get all this stuff?
I just ordered the gears. What do I have to have to install them?
(99 Cobra)

 

B

BEATNGU

Founding Member

Jun 22, 2002

346

0

0

WestCentral, NY

Aug 12, 2004

#5

• Aug 12, 2004

• #5

300hpWRX said:

Do you need the pack kit if your rear end is still intact?
Where's a good place to get all this stuff?
I just ordered the gears. What do I have to have to install them?
(99 Cobra)

Click to expand...

Yes, the clutch packs keep your limited slip working properly. If your packs are burnt/worn you will get the 1 wheel peal.
You can buy the kit at your local Ford Parts dept.
You will only need gear lube and I suggest a new pinion bearing incase you wreck the other pressing the stock one off. Or just leave it on the 3.27 pinion and use the new one on your new set.