allignment issues chewing up tires.

dp88

New Member
Oct 30, 2008
40
0
0
I have had an ongoing allignment issue due to what i can olnly guess is the lack of c/c plates after lowering. I recently installed a set of the ford racing lowering springs and have since noticed the top of the tire is angled in to the engine bay on both sides but more angled on the drivers side. The inside of both tires are wearing prematurely but again the driverside more. The car does want to pull to the right as well. I have replaced the ball joints already and would appreciate some input on if you think it is time to get c/c plates, and if it is common for one side to be out of wack more than the other. Tkanks for your help.
015.webp
 

Attachments

  • 015.webp
    015.webp
    104.9 KB · Views: 190
Yes, the cc plates are the best way to correct this. You could try enlarging the upper strut mounting holes but the plates will almost certainly allow a good alignment.

After I installed the Ford lowering springs, a shop aligned it, and showed me the printouts indicating that they could still get it within the factory specs. That actually allows quite a bit of variation from optimum. But it still pulled to one side noticeably, and they were out of adjustment to correct it.

So I got the plates. Because the first shop was closed when I got the plates on, I went to a much smaller shop where the owner worked on antiques and rods and such. He set it up nicely so that it drove straight, did not wear tires, etc, and has been doing all of my alignment since 92.
 
Can someone point me in the right direction of some good c/c plates. Im not sure which ones i should get because i have to keep the stock hood. Thanks