• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Alternator not charging

  • Thread starter Thread starter '88WhtNtchBck$
  • Start date Start date Aug 17, 2007
8

'88WhtNtchBck$

New Member
Aug 17, 2007
33
0
0
Jersey
Aug 17, 2007
#1
  • Aug 17, 2007
  • #1
Hello there, i'm extremely frustrated, i pulled my motor to replace the oil pan gasket, now my alternator won't charge, i thought mine took a **** so i bought a 140 amp powermaster one wire, and it still won't charge, any suggestions on where to look for the problem?i checked the fusible links by the solenoid and they were positive for power, but i don't know how it won't charge with a simple one wire, help much needed, thanks for your time!
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Aug 17, 2007
#2
  • Aug 17, 2007
  • #2
You have a fused 4 or 2 AWG cable for your 140 amp alternator, right? If so, you largely will not have to worry about the OEM wiring.

Good luck.
 
8

'88WhtNtchBck$

New Member
Aug 17, 2007
33
0
0
Jersey
Aug 18, 2007
#3
  • Aug 18, 2007
  • #3
i'm not sure wut to look for at this point,when i jump the car the voltage stays real low until the car dies out of spark, i was looking for bad grounds or something but i was hoping for some direction on where to start looking for problems, ???????????
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Aug 18, 2007
#4
  • Aug 18, 2007
  • #4
More info about your wiring set-up will help.

A true one wire alternator needs to see around 1500 RPM or so in order to 'start' charging. This RPM threshold is what excites them. Are you doing this?

If you are needing a jump or a battery charger, and you used the OEM charge wiring, you very well probably blew a fusible link or two. The stock wiring cannot handle even half of that new alt's possible output. Once you run your new charge cable (personally I would use 2 AWG and an ANL fuse), this should all but solve the issue, unless you have a bad alt.

Good luck.
 
8

'88WhtNtchBck$

New Member
Aug 17, 2007
33
0
0
Jersey
Aug 18, 2007
#5
  • Aug 18, 2007
  • #5
no i'm using newcharge wire that came with alternator, i even put my buddy's alt in to see if i had a dud, but his didn't work either, i'm stumped
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Aug 18, 2007
#6
  • Aug 18, 2007
  • #6
Is there a fuse on your new charge cable? Is it blown? Was your alt tested in your friend's car?
Yours can also be bench tested at parts stores.

Is it being revved enough to excite?
 
8

'88WhtNtchBck$

New Member
Aug 17, 2007
33
0
0
Jersey
Aug 18, 2007
#7
  • Aug 18, 2007
  • #7
unfortuneately yes, i'm thinkin its something i unplugged or didn't groung when i put the motor back in that has something to do with the charging system, i looked everywhere but havn't found anything yet, Being that everything is hooked up right with the alternator, i need to know where to look for further problems, i'm just using the one wire no oem. My reg wires are pretty beat up though, would it hurt to cut them out in case of a short somewhere?
 
8

'88WhtNtchBck$

New Member
Aug 17, 2007
33
0
0
Jersey
Aug 18, 2007
#8
  • Aug 18, 2007
  • #8
I hate electrical problems!!!!!!!
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Aug 18, 2007
#9
  • Aug 18, 2007
  • #9
The secondary power ground is between the back of the
intake manifold and the driver's side firewall. It is often missing or
loose. It supplies ground for the alternator, A/C compressor
clutch and other electrical accessories such as the gauges.
Any car that has a 3G or high output current alternator needs
a 4 gauge ground wire running from the block to the chassis
ground where the battery pigtail ground connects.

The 3G has a 130 amp capacity, so you wire the power side
with 4 gauge wire. It stands to reason that the ground side
handles just a much current, so it needs to be 4 gauge too.

The picture shows the common ground point for the battery & alternator

Picture courtesy timewarped1972
 

Attachments

  • ground.webp
    29.6 KB · Views: 133
8

'88WhtNtchBck$

New Member
Aug 17, 2007
33
0
0
Jersey
Aug 18, 2007
#10
  • Aug 18, 2007
  • #10
I appreciate the detail and help, i have the ground at the back of the motor to the firewall, but are you saying that where my battery grounds to the block, i need a ground going to the fender well as well?It makes sense i just wanna be sure though. And would it hurt to cut out my stock wires for the old alternator to clean it up a bit and narrow down my problem in case there is a short, cuz they look pretty hacked up with butt connectors and electrical tape, although there is current running through them. Thanks for your time, i'm in desperate need of good advice!
 

enyawix

Member
Dec 18, 2005
507
0
19
127.0.0.1
Aug 19, 2007
#11
  • Aug 19, 2007
  • #11
Make life easy get a GM1 wire alternator, and swap the pulley. They are cheap at local part stores.
 
You must log in or register to reply here.

Similar threads

Electrical Alternator not charging after terminator 2 install.
  • Sfab79
  • Aug 24, 2025
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
41
Views
2K
Fox 5.0 Mustang Tech Aug 21, 2026
Qtrhrse23
Alternator not charging
  • SchwarzStock
  • Jul 6, 2026
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
3
Views
269
1965 - 1973 Classic Mustangs -General/Talk- Oct 17, 2026
SchwarzStock
Electrical Parasitic Draw, Fuse 8
  • N8827N
  • Sep 15, 2026
  • Fox 5.0 Mustang Tech
Replies
6
Views
290
Fox 5.0 Mustang Tech Sep 18, 2026
AeroCoupe
A
Resolved Electrical Help Please
  • Alabama
  • Jan 22, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
378
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jan 22, 2026
AeroCoupe
C
Stock 1993 charging issue at idle
  • Charlie1
  • Sep 21, 2025
  • Fox 5.0 Mustang Tech
Replies
7
Views
477
Fox 5.0 Mustang Tech Sep 24, 2025
Mustang5L5
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?