anyone have coilover pics

Green&GoldGT · Nov 30, 2007

Right now I'm looking at buying the Granatelli or MMR drag coilovers along with Lakewood 90/10 struts. Does anyone have pics of their coilover setups(I'm looking for pics set at their lowest)?

So to run coilovers I would need 4 bolt caster camber plates and what else?

Thanks

CobraRed_96_GT · Nov 30, 2007

EpikGT's:

blacknblue2002 · Nov 30, 2007

This is the lowest I ever wanted my car....but the front had a lot more travel left on the threads...and the rear had even more....Maximum Motorsports will allow for upto 5 1/2" of drop if you ever so desired (although I don't think it's even possible)...and you could even lift the car a bit if you really wanted

Saleen311 · Nov 30, 2007

blacknblue2002 said:
This is the lowest I ever wanted my car....but the front had a lot more travel left on the threads...and the rear had even more....Maximum Motorsports will allow for upto 5 1/2" of drop if you ever so desired (although I don't think it's even possible)...and you could even lift the car a bit if you really wanted

damn. that looks good. how much did you pay for your set up

blacknblue2002 · Nov 30, 2007

That setup is simply the 'full coilover set' from Maximum Motorsports w/ billstein race rated shocks/struts...and the 4 bolt Caster Camber plates to help line everything up...don't remember how much it was but I do remember it being rather pricey

tomustang · Nov 30, 2007

Where did you get the thought of buying granatelli coilovers??

View attachment 344766

superstang01 · Nov 30, 2007

justinschmidt1 · Nov 30, 2007

superstang01 said:

Thats pure sex...then again my car is just as low in the front with sportlines, no iso's...The back is a little higher but I like the raked look for now.

Winters98GT · Nov 30, 2007

too low

Poisoned Pony · Dec 1, 2007

superstang01 said:

holy crap, that is LOW! I kill my exhaust as it is with my H&R's, I can't imagine what I would do with that!

EPIK · Dec 1, 2007

Dont EVER buy Granatelli suspension parts..They are MM copycat, put are pure JUNK!!!!

They might look the same but are far lesser quality....

This is my car with MM coilovers/Bilsteins in front & adjustable LCA's in the rear, with rear coilovers supposed to be installed soon...This is nowhere near the lowest setting, but its too low already & I couldnt imagine how horrible the ride would be if I went any lower...

View attachment 344491
View attachment 344493

Green&GoldGT · Dec 1, 2007

What about the MMR drag coilovers? or does anyone else make quality drag coilovers for the front? i couldn't find drag ones from MM

blckstng96 · Dec 3, 2007

The only thing that determines it being a drag set up or not is the spring rate.

PonyboyIsaac · Dec 4, 2007

heres a stupid question but i'll ask anyway, is it possible to go back to almost stock ride height with coil overs? you know, for those times when you know your going somewhere with alot of speed bumps that can jack up your exhaust. (i have longtubes, this is why i'm asking)

Blinkstang · Dec 4, 2007

PonyboyIsaac said:
heres a stupid question but i'll ask anyway, is it possible to go back to almost stock ride height with coil overs? you know, for those times when you know your going somewhere with alot of speed bumps that can jack up your exhaust. (i have longtubes, this is why i'm asking)

"Whatever the ride height desired, whether it's stock or lowered, the MM coil-over kit can provide it." - Straight from MM's site.

BurningRubber · Dec 4, 2007

superstang01 said:

PonyboyIsaac · Dec 5, 2007

Blinkstang said:
"Whatever the ride height desired, whether it's stock or lowered, the MM coil-over kit can provide it." - Straight from MM's site.

wow, thanks man, thats good to know. I might see a coilover kit in my near future.

Green&GoldGT · Dec 6, 2007

What is the spring rate for drag setups? and where's a good place to order MM coilovers?

Also how hard is it to adjust them and is there anything else I need other than 4 bolt CC plates and struts?

BTW the cars above look awesome

EPIK · Dec 6, 2007

Green&GoldGT said:
What is the spring rate for drag setups? and where's a good place to order MM coilovers?

Also how hard is it to adjust them and is there anything else I need other than 4 bolt CC plates and struts?

BTW the cars above look awesome

I think the softest spring MM offers for the front is 225lbs. the only other thing that is mandatory for coilovers that I can think of are struts & shocks, & a good alignment. MM only makes coilovers for bilstein, Koni, & tokico.

alot of places carry MM products. I order all my Mm stuff from a place called atlantic coast mustang (acmustang.com). They give me great prices & save me on shipping & sales tax (since Mm is in California). There home page actually has a pic of my old 97 Cobra LOL!!!

heres a link....I just usually call the number & talk to a guy named sean...

http://acmustang.com

anyone have coilover pics

Member

Active Member

Attachments

Member

Attachments

New Member

Attachments

Member

Psychotic Member

Active Member

Attachments

Member

Attachments

Whoop...whoop-whoop-whoop-whoop...GANGNAM STYLE!!!

Attachments

Member

Attachments

Member

Member

New Member

Member

Attachments

New Member

Member

Member

Similar threads

Privacy & Transparency

Privacy & Transparency