well i'm pissed ,99 cobra just 020 overed ,new valve guides,all new bolts too.my pass side head is leaking from the rear of the head....where the oil passage runs to the head.....has anyone tried this stuff in a can? does it work? does it mess up new bearings and seals.?....or should i retoruqe the back 2 head bolts..or pull the head agian? thanks i'am pissed . ....what the best name brand of sealer to get ? iam selling this car ,and it wont go away.
ANYONE TRIED HEADGASKET SEALER?
- Thread starter nitrous408
- Start date
Outlaw97GT
Member
Don't put that sealer junk in you car. It will gum up your rad., waterpump, or anything else in your cooling system.
no do not use that..
I hate to say it but you have to pull the head.. I have seen a 32v 4.6 with this problem after the heads were done at my shop.. turned out to be a defective head gasket.. it was folded over near one of the oil passages.
I hate to say it but you have to pull the head.. I have seen a 32v 4.6 with this problem after the heads were done at my shop.. turned out to be a defective head gasket.. it was folded over near one of the oil passages.
