aod to t5

izzleon

New Member
May 7, 2007
22
0
0
hey whats up guys well im here to get some info on the swap.....but none have info of where i can get the bolts....i have everything for the swuap except the bolts.. no do i need to use the same crossmember? how about the shifter area is there any cutting?help would be verry well ppreciated...thanx
 
The crossmembers are the same. You will need the transmission harness. it starts at the left kick panel and goes through the trans tunnel to the trans. You also must cut the front of the hole in the floor out about an inch or so to get the front of the shifter to clear. With a buddy and all the right parts you can swap it in an afternoon.
 
The two upper bolts get replaced with 7/16" x 1.5" coarse thread bolts. I got them out of the Dorman selection in my local auto parts store for .93 each.
 
if you're lazy, just put washers on the top two bell bolts and be done with it. You'll never see it.

don't re use your old flywheel bolts, they're shorter. Get the arp flywheel bolts from summitracing or brothers...only $10.

as well, get the ford racing pressure plate bolt kit.

as for the bell to trans bolts, that should come with the trans you buy, if not, take the bell into the hardware store, and buy some nice bolts for it there.

the x member will likely bolt right in from your aod car, but you may have to cut/grind the welds off of the tubes on the left and right side of the x member. this allows the tubes to slide forward and back to adj for x member positioning. Again though, I've never had an issue using the aod piece.