if you're lazy, just put washers on the top two bell bolts and be done with it. You'll never see it.
don't re use your old flywheel bolts, they're shorter. Get the arp flywheel bolts from summitracing or brothers...only $10.
as well, get the ford racing pressure plate bolt kit.
as for the bell to trans bolts, that should come with the trans you buy, if not, take the bell into the hardware store, and buy some nice bolts for it there.
the x member will likely bolt right in from your aod car, but you may have to cut/grind the welds off of the tubes on the left and right side of the x member. this allows the tubes to slide forward and back to adj for x member positioning. Again though, I've never had an issue using the aod piece.