Attn: Killer Paul

[badingle]

hey man, I just put in my PA racing K member and my passenger side motor mount isnt not lining up. The bolt goes in but the allignment stud is about 1/4" off. I have energy suspension mounts.

I know you just installed one, Did you run into this too?


-Andy

 

[Killercanary]

If you are refering to the little "pin" in the motor mount all you need to do is take the motor mount apart, cut the weld, and knock the pin out. Its very easy to do. Hope that helped. I have poly motor mounts as well.

 

[badingle]

Thanks Paul!!! That will do it. I wasnt sure if that was a needed item or not.

 

[super302]

I'm so confused!

 

[badingle]

I'm so confused!

 

[super302]

 

[DARK-5.0]

Makes plenty sense to me

Jeremy

 

[YEAHLOH95]

there is an alignment pin on the motor mounts ,that hits on the k-member ,and won't let it sit flush ,so youhave to remove it .