Does anybody know what size hole is used on Edelbrock's RPM intake for the water temp? I have the Autometer Mech Water temp gauge #4432. The gauge is the Ultralite Series.
The intake hole is too small for the fitting supplied with the gauge, so I need to buy the proper fitting/reducer so I can mount the sensor/probe from the gauge into the Intake.
Any help is greatly appreciated
Thanks,
Scott
The intake hole is too small for the fitting supplied with the gauge, so I need to buy the proper fitting/reducer so I can mount the sensor/probe from the gauge into the Intake.
Any help is greatly appreciated
Thanks,
Scott