Bearing problem?

Wicked_306

New Member
Aug 14, 2005
45
0
0
I put my 306 shortblock together and turned it over by wrench and it didnt feel right. I took the piston assembly back off and the bearings had scratches in them just from turning it over by hand a few times. They will catch your finger nail. There are scratches in each rod bearing top and bottom. I used molly grease on them. what would cause this? I am pretty sure the crank has never been turned before. I polished it up. The journals are smooth. All bearing surfaces were clean and i was very clean during assembly. Could the molly grease be the problem? Do I need to get the crank turned? I have not check the main bearings yet but will and I'll let yall know what they look like. These are Federal mogul speed pro standard size bearings too. Thanks

Travis