Beginning PI Swap Need A Full How To!!!

[mustangman9812]

I am doing it myself. I am pretty mechanically inclined so i need a full FAQ or how to. I know pretty much how to do most of it but i dont want to mess-up and have to take it all back off again. So I need a really good FAQ or How to Please!! :SNSign:

 

[NPIGT]

http://www.bossracing.net/Tech Articles/PI Headswap/PI Head Swap page1.htm

http://www.eccentrix.com/members/46mustang/headswap.html

Hope this helps! Post some numbers after!

 

[DropTopPony]

did you buy new PI heads? Make sure when you take off your NPI heads to place them next to the new ones. Look for any holes that are not plugged in the new ones and plug them with the plugs from the old heads. These would be the oil galley plugs and can make your life hell. Be sure to read both of those articles and pick up a haynes/chiltons manual for proper torque specs etc..good luck.

 

[tomustang]

Make sure you get the right heads

 

[streetstang03]

i have a few write ups here of the PI swap:

http://www.stangette.com/community/showthread.php?t=120

 

[tomustang]

i have a few write ups here of the PI swap:

http://www.stangette.com/community/showthread.php?t=120

sorry I don't go there anymore

 

[streetstang03]

make a new user name fool!! i'll take care of the rest

 

[mustangman9812]

Thanxs

 

[mustangman9812]

I am also using used PI Heads and Cams.

 

[97saleen13]

reuse the metal and rubber hoses that go under the manifold to make a new one just cut the metal one til its straight and connect the bent rubber one to the block and the metal one then just buy a lil more hose to finish it off it worked perfectly on mine