body holes/scoops

5.0n66

New Member

Nov 19, 2002

88

0

0

New Holland (Lancaster, PA)

Jul 1, 2004

#1

• Jul 1, 2004

• #1

has anyone filled the holes left by the rocker chrome and the holes left by the "E" quarter molding? I'm assuming the procedure is weld-grind-bondo-sand-primer-sand-etc

also has anyone installed the side scoops that go over where the "E" quarted moldings go?.... How is this done? I had a set on before I began the restoration but was never happy with the mounting... bolt through the flanges?

 

6

'69Mach1Chick

There's no grass left to cut.

Apr 1, 2002

348

0

0

North Jersey

Jul 1, 2004

#2

• Jul 1, 2004

• #2

Where do you mean? I have no idea where you are talking about but it sounds like the typical procedure

 

5.0n66

New Member

Nov 19, 2002

88

0

0

New Holland (Lancaster, PA)

Jul 1, 2004

#3

• Jul 1, 2004

• #3

rocker molding = the chrome part under door on the rocker panel... goes from front wheelwell to rear wheelwell

"E" quarter panel molding = the chrome piece that is in the recessed area between rear of door and front of rear wheelwell... on '66s it looks like the capital letter E... one '65s it is more of a vertical bar

 

6

'69Mach1Chick

There's no grass left to cut.

Apr 1, 2002

348

0

0

North Jersey

Jul 1, 2004

#4

• Jul 1, 2004

• #4

you can weld grind sand primer it. When we replace the inner or outer rockers we can sometimes save them. We just use patches and weld them and grind it down. Then we use a d/a sander and just spray red primer. If you use a plasma cutter and cut out squares around the holes, it is easier. Then you can make a template out of tape and put a metal patch there. Use a strong magnet to hold it in place when you tack it. This will get you a nice flush patch.

 

5.0n66

New Member

Nov 19, 2002

88

0

0

New Holland (Lancaster, PA)

Jul 2, 2004

#5

• Jul 2, 2004

• #5

holes are small enough to plug weld shut....cutting squares make alot more work and greatly increases chance of warping..............has anyone actually installed or watched someone install the side scoops? how is it done?

 

R

Ronstang

New Member

Apr 4, 2004

1,294

0

0

Houston Texas

Jul 2, 2004

#6

• Jul 2, 2004

• #6

The side scoops are riveted in from the inside.....at least that is how Carroll did in on my Shelby.

 

6

'69Mach1Chick

There's no grass left to cut.

Apr 1, 2002

348

0

0

North Jersey

Jul 3, 2004

#7

• Jul 3, 2004

• #7

Why did you ask then? Just plug them shut.

 

allcarfan

The Answer Man

Founding Member

Apr 8, 2001

2,458

1

56

North Atlanta

Jul 3, 2004

#8

• Jul 3, 2004

• #8

if you dont want to weld them shut, you can use small pieces of fiberglass. My sidesccops are rivited from the inside, and then glassed in.